Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

How to work out cv centreline?

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 4426
Joined: Mon Mar 22, 2004 4:39 pm
Location: Sunshine Coast

How to work out cv centreline?

Post by bru21 »

I need to work out the cv centreline (pivot node) for my ifs buggy.

They are NH pajero plunging cv's.

Can I pull them down and find the centre of the groove in the outer race or it there a better / more accurate way. I need to design the width of the front and rear lower chassis hence I need the cv centreline to draw a line through, to make sure the upper and lower arms pivot on center.

cheers bru
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Top
Posts: 1676
Joined: Tue Oct 22, 2002 9:26 am
Location: brisbane

Post by 1MadEngineer »

some helpful info
http://www.rowland2.com/products/universalJoint.htm
WWW.TEAMDGR.COM
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
Top
Posts: 4426
Joined: Mon Mar 22, 2004 4:39 pm
Location: Sunshine Coast

Post by bru21 »

Thanks mate as always.
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests