Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Opinions on 3 Hiluxs

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 860
Joined: Sat Mar 07, 2009 1:14 pm
Location: Newcastle

Opinions on 3 Hiluxs

Post by ethann »

Hello,

I was just wondering what people thoughts are on these three Hiluxs and which should I go for?

#1 - Gen 2 (Not sure the exact year model) 2.4 deisel, 5 speed, 31's, Alloy tray, Average interior, White with a yellow bonnet. Overall good condition. Pretty standard. Requires blue slip. $1500

#2 - Gen 2 1985, Has had a 2.8 Diesel put in it, Looks to standard height, Rancho 5000's under it, Been sitting in the paddock for a little while so everything will need going over, Alloy tray, Bodys a bit rough Will require a new paint job. And a good clean up. Requires blue slip. $1000 firm

#3- Gen 2 (Not sure the exact year model) Rb30 engine, Has got a lift, Tough dog steering dampner, After market shocks (not sure the exact ones they will either be tough dogs or ranchos), 31's, Fairly good overall condition, Comes with a spare motor, Only just ran out of rego, Bull bar and the radiator on the tray with thermo fans. Only problem that I was told is that when the fella drove it home it ran a little bit hot, He didn't check the water or anything so it could be anything from no water to the termestate. $1500


I think I'll steer clear of the 2.4 as I've been told there pretty gutless.
I'm kinda tossing up between the 2.8 and the rb30.

What do you guys think?

Cheers.
Team Lock n load.
www.facebook.com/locknloadaustralia
Posts: 2585
Joined: Fri Mar 28, 2008 4:45 pm
Location: SYDNEY

Post by thehanko »

as tempting as option 3 is I think i would stay clear.

does it have engineering for the engine swap? if not expect to spend $ before you can register it. parts are cheap for rb 30's but sometimes engine swaps never quite get the cooling system right. if there was no water then it would not usually read hot, as there is no water for it to read ;) the rb30 i had in a lux had a commo turbo rad with twin thermos and never ran hot.

I think option 2 would be my choice. but again check to see if you need eng for the engine swap.

can you take it for a bluey before you buy? as they will probably give you a list of jobs before rego and could effect you decision to buy.
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Posts: 317
Joined: Thu Dec 11, 2008 8:22 pm
Location: Oriental 4WD Adelaide

Post by mhgill »

They all sound like trouble to me, Ones had a prang in the front, ones been sitting in a paddock for ages and the others had a engine conversion!

But you can't really tell what a car's like from a forum, espcially without pictures.
GQ 5" coils 35" Muds FOR SALE
98 GU 4500 ST Stock.
Posts: 860
Joined: Sat Mar 07, 2009 1:14 pm
Location: Newcastle

Post by ethann »

thehanko wrote:as tempting as option 3 is I think i would stay clear.

does it have engineering for the engine swap? if not expect to spend $ before you can register it. parts are cheap for rb 30's but sometimes engine swaps never quite get the cooling system right. if there was no water then it would not usually read hot, as there is no water for it to read ;) the rb30 i had in a lux had a commo turbo rad with twin thermos and never ran hot.

I think option 2 would be my choice. but again check to see if you need eng for the engine swap.

can you take it for a bluey before you buy? as they will probably give you a list of jobs before rego and could effect you decision to buy.
Well I'm not sure if it's got the engineers cert or not, But it's all properly done so I doubt that it would be very hard to get it engineered?
You wouldn't have a rough estimate on what the engineer cert would cost for the engine conversion?

The one reason im weary on the rb30 is, Is that I like to go through water =p.
I think I might be able to knock him down a little bit on the price if it doesn't have the engineer cert?

But the etc power would push bigger wheels nice, And it wouldn't be hard to put a turbo on it once I'm off my p's.

I'm going to have 5 g's to spend, I would rather kinda buy something stock ish and build it my self, (Get flexy etc).

But the one with the rb30 has got abit of a lift and stuff so that would most likely benifit me in the long run.

But in the same token the 2.8 would be nice for the fact I can go through water haha.
The fact I have to spend a little bit of money on something I'd prefer that in the long run because I know what it's had replaced etc.

It's a hard decision haha.
Team Lock n load.
www.facebook.com/locknloadaustralia
Posts: 169
Joined: Mon Jul 14, 2008 4:20 pm
Location: CQ, Aus

Post by Zook_Fan »

Hey im not to sure what the laws for P's are down there but if they are the same as queensland option 1 is the only one you could drive till you are off your p's. Double check with the authorities before you make your decision
[quote="v840"]Do you ever think that if Hitler had targeted idiots instead of Jews, shit might have gone down a lot differently?[/quote]
Posts: 860
Joined: Sat Mar 07, 2009 1:14 pm
Location: Newcastle

Post by ethann »

Zook_Fan wrote:Hey im not to sure what the laws for P's are down there but if they are the same as queensland option 1 is the only one you could drive till you are off your p's. Double check with the authorities before you make your decision
Nah I can drive them all.
At the moment I have a turbo Pajero. and it's 110% legal. =)
Team Lock n load.
www.facebook.com/locknloadaustralia
Posts: 2585
Joined: Fri Mar 28, 2008 4:45 pm
Location: SYDNEY

Post by thehanko »

mhgill wrote:They all sound like trouble to me, Ones had a prang in the front, ones been sitting in a paddock for ages and the others had a engine conversion!

But you can't really tell what a car's like from a forum, espcially without pictures.
x2.

but at least with a 5k budget you can buy all 3 and have spares :lol:.

Personally i would keep looking you can get a decent rig for under 5k, or a decent stocker for a couple of grand.

anything your buy for 1000-1500 is likely to be a pos pia regret.

but gems do come by if your not in a rush.
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Posts: 995
Joined: Sun May 01, 2005 2:55 pm
Location: Tamworth

Post by Turbo Tonka »

number two sounds like the better one to me but in saying that i dont think my 2.8 is any better a motor than mates 2.4s and especially not my old 2.4 turbo

If you can though id buy something for a little more money that goes and is regoed,save yourself the trouble and enjoy driving it.

Don't know what the rb30 would be like,couldnt be too bad i guess if it is legal.??

appsie
sierra truggy,37 sticky treps,propane,6.5s and disconnect,lux diffs with spools,16" fox shox,hydro steer.
Posts: 3
Joined: Thu May 07, 2009 11:19 am
Location: pilbara

Post by benno1172 »

Ha I wouldnt touch any of them.Try and buy something thats still standard..
Posts: 860
Joined: Sat Mar 07, 2009 1:14 pm
Location: Newcastle

Post by ethann »

Yeah, I'm thinking of just getting a Pootrol like I originally wanted lol.
Team Lock n load.
www.facebook.com/locknloadaustralia
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest