Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
im after some information on axle lengths and the difference between 60 series and 80 series
i know the 80 series is a wider unit but a lot of that is in the hub so im wondering if my 30spline 60 series longfields and cv's will fit into the 80 series housing?
also will the 80 series hi pin diff take the abuse from a 350 chev in a vehicle that weighs 2T?
cheers in advance
If you allready know everything, DONT ask fcuking Questions!!
cheers for the info. sold 60's longs and bought 80 series longs and so far the hi pin diff has taken the abuse fine pity i blew the rear carrier pin to bits half way thru a winch challenge too much foot while bouncing, had a lockright in the rear which is the cause of breakage due to too much lash and getting a big foot full. has now been replaced with ARB to match the front ... still learning to drive the new setup
If you allready know everything, DONT ask fcuking Questions!!
pity i blew the rear carrier pin to bits half way thru a winch challenge 
too much foot while bouncing, had a lockright in the rear which is the cause of breakage due to too much lash and getting a big foot full. has now been replaced with ARB to match the front 
... still learning to drive the new setup 
