with heaps of charge in battery engine cranks very very slowly until it fires... just seems to have happened suddenly.
any ideas??
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
TD42 slow to start
What sort of charge in the battery?
What amperage/voltage is the starter cranking at?
What is the alternator charging at?
Have you given the battery a good fast charge with a battery charger then tested it independently of the vehicle?
Is there voltage drop between the battery terminal & the starter?
When you mean slow to start, what does it do?
Cold Hot?
Batteries can hold voltage but give up when load is applied.
Need a bit more info befoer anyone can help even a little bit.
What amperage/voltage is the starter cranking at?
What is the alternator charging at?
Have you given the battery a good fast charge with a battery charger then tested it independently of the vehicle?
Is there voltage drop between the battery terminal & the starter?
When you mean slow to start, what does it do?
Cold Hot?
Batteries can hold voltage but give up when load is applied.
Need a bit more info befoer anyone can help even a little bit.
Don't ask me, ask them. I'm just runnin for my life myself.
Well they are all following you...
No they ain't, I'm just in front...............
Well they are all following you...
No they ain't, I'm just in front...............
Could be the solenoid or dirty brushes, pull the starter out and take the back off the actual motor bit, by first undoing the two hex screws then the 8mm bolts, the assembly will come off completely, use some fine sand paper and clean the ends of the brushes and the brass comutater that they are in contact with, normally makes a masive difference.
Also check both cables on the back of the solenoid are tight.
Also check both cables on the back of the solenoid are tight.
Who is online
Users browsing this forum: No registered users and 4 guests