Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

help on 4.5 80 series motor

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 2
Joined: Tue May 12, 2009 6:19 pm
Location: toongabie vic

help on 4.5 80 series motor

Post by pete4x4 »

got a 97 80 series landcruiser 4.5 petrol on gas has slight miss at idle and hesitation on acceleration but doesnt seem to bad up high revs pulled plugs out and don comp test no 1 at 60 psi and al the rest on 180 psi put bit of oil in and goes upto 65 psi wondering if it would be exaust valve or head gasket not blowing smoke so ant be rings any help would be great thanx
Posts: 53
Joined: Thu Jul 24, 2008 5:29 pm
Location: melbourne

Post by V8 Hilux »

Just recently had the same problem with my 80 series! Burnt out exhuast valve will most likely be the cause. Mine was down at 30 psi on the dead cylinder rest 175psi. pull the valve cover off and check the clearences - exhaust valve will have run out of clearance and burnt out.

it cost me 1100 to get my head done up (only needed two exhaust valves and all new exhaust seats inc VRS gasket set)

After you get the head done up get it dyno tuned to make sure not running to lean and probably need to check valve every 40thou or less as gas burn hotter and than get get out of spec bit faster.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests