Will this work?

[SuperCruiser]

Will my 1989 HJ75 diff centers with the factory cable diff locks fit into 80 series housings with 80's axles? I ask because I want to do a coil over conversion in the future

[Ice]

Will my 1989 HJ75 diff centers with the factory cable diff locks fit into 80 series housings with 80's axles? I ask because I want to do a coil over conversion in the future

In short no

[dumbdunce]

the rear will fit, the front will not.

but

the front cable locker is the same as the rear so you should be able to sell it for enough to buy an air locker to put in the front 80 series housing.

[tiler0172]

i think the housing is different on the rear to but i am not shore

[SuperCruiser]

ok Cheers for the help guys

[beinthemud]

The long answer is no

[SuperCruiser]

Ok, I have been thinking about this again guys. Sorry If I ask things in a such nub fashion but I'm learning

the rear will fit, the front will not.

but

the front cable locker is the same as the rear so you should be able to sell it for enough to buy an air locker to put in the front 80 series housing.

Cheers for the idea mate but I want to retain the both factory lockers...So if the rear fits, that's great! So what other options do I have have for the front? Can my front housing be modified with custom axles? Or can a front 80 diff housing be modified to suit my front center?

[DR Frankenstine]

Ok, I have been thinking about this again guys. Sorry If I ask things in a such nub fashion but I'm learning

the rear will fit, the front will not.

but

the front cable locker is the same as the rear so you should be able to sell it for enough to buy an air locker to put in the front 80 series housing.

Cheers for the idea mate but I want to retain the both factory lockers...So if the rear fits, that's great! So what other options do I have have for the front? Can my front housing be modified with custom axles? Or can a front 80 diff housing be modified to suit my front center?

NO

[oldmate]

the problem with the front in the 80 is the diff is a high pinion - needed to clear the tie rod. What I don't know though is if the diff will bolt in and the axle spines slot in regardless of the tie rod. If it does then it would be possible to relocate the tie rod to the front with a custom high steer setup - an option if you're going to lift greater than 4 inch. only other options are an air locker as mentioned, or a factory 80 series locker but they are electric and hard to come by.

[GO79]

Yes mate it will just have to do a lil grindin and add two more studs to the bolt holes in your diff i but will only fit in the rear diff
checks out ih8mud.com its been done a bit and done with the factory elitric lockers to

[80's_delirious]

short answer is NO

[Harb]

and the inbetween answer is also no

[a-frame81]

I would imagine you could always cut the mounts off your old diffs and custom fab some coil mounts etc. Just my 2c. Easier than trying to fit your lockers into 80series diffs...

[GO79]

short answer is NO

Where are you getting this NO answer if heaps of people do it so it must be a YES