Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
coils AND leaves?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
coils AND leaves?
something ive never seen before??
is this a common thing?
is this a common thing?
my GUBanzy wrote:Dial up internet.........you'd post something and come back 2 beers later to see if it loaded.
Posts: 3725
Joined: Wed Jun 30, 2004 1:45 pm
Joined: Wed Jun 30, 2004 1:45 pm
Location: Blue Mountains, or on a rig somewhere in bumf*ck idaho
I've seen this done with both coils and airbags. Typically done to carry a load. I like the idea with either coils or airbags, because you can have easily adjustable spring rates by changing coils or air pressure. before changing to full coils I was toying with having a 3 or 4 leaf rear pack with longer main and wraps and extended shacklesthat effectively only located the axle, and airbags to carry the weight. Mainly because i was sick of having to change leaf packs to go from flex queen to travelling.
http://www.populationparty.org.au/
I seen this on a hilux years ago and they where there as the main load bearing spring the leaf springs only located the diff housing. it had a good deal of flex with the setup too.That's the time i have seen it.
TEAM TONKA
SPONSORED BY
HANCOCK SHEETMETAL
Locktup4x4.com.au
FOR ALL HARDCORE OFFROAD GEAR
SPONSORED BY
HANCOCK SHEETMETAL
Locktup4x4.com.au
FOR ALL HARDCORE OFFROAD GEAR
I had a similar setup in my Hilux by Outback Suspension. It used coils for lift so that the vehicle sat about two inches higher than the leaves if you removed the rear shackle pins. The front had two leaves per side and the rear had three. As HANCOCK said, the leaves pretty much only located the axle. It was really good and had good flex. It only rode on the coils unless it really loaded up and then the leaves kicked in. I would definitely reccommend it as a second to a full coil conversion.
I'm amazed that outback suspension still operates. Such a dumb idea.
High spring rate for load carrying but with poor axle location
every year, outback turn up at Wandin with their 60 series with even more stuff stuck on it, like it's a cool idea to have a dangerously overloaded car so long as the springs hold it up.
Sadly there's no photos of their hideous junk on their website. The front end of the hiluxes they do are especially amusing.
Just my opinion of course.
Steve.
High spring rate for load carrying but with poor axle location
every year, outback turn up at Wandin with their 60 series with even more stuff stuck on it, like it's a cool idea to have a dangerously overloaded car so long as the springs hold it up.
Sadly there's no photos of their hideous junk on their website. The front end of the hiluxes they do are especially amusing.
Just my opinion of course.
Steve.
[quote="greg"] some say he is a man without happy dreams, or that he sees silver linings on clouds and wonders why they are not platinum... all we know, is he's called the stevie.[/quote]
Posts: 3725
Joined: Wed Jun 30, 2004 1:45 pm
Joined: Wed Jun 30, 2004 1:45 pm
Location: Blue Mountains, or on a rig somewhere in bumf*ck idaho
You're right. I've never seen the people you're talking about but there's definately the chance of axle wrap when using only a couple of leaves and the coil helpers. There's definately a middle ground and sometimes you have to make the call and say that if your trucks for hard play then chances are it's not going to be suitable for hard travel.Gwagensteve wrote:I'm amazed that outback suspension still operates. Such a dumb idea.
High spring rate for load carrying but with poor axle location
every year, outback turn up at Wandin with their 60 series with even more stuff stuck on it, like it's a cool idea to have a dangerously overloaded car so long as the springs hold it up.
Sadly there's no photos of their hideous junk on their website. The front end of the hiluxes they do are especially amusing.
Just my opinion of course.
Steve.
http://www.populationparty.org.au/
Posts: 3725
Joined: Wed Jun 30, 2004 1:45 pm
Joined: Wed Jun 30, 2004 1:45 pm
Location: Blue Mountains, or on a rig somewhere in bumf*ck idaho
Just looked at their website. What a crap site! It must have been designed by a 4 year old. They can't spell "urathane" properly and some pics would be good.Outback suspension website wrote:
Traveling on corrugated roads is a lot more comfortable with OUTBACK SUSPENSION because the leaf springs are being controlled by a frictionless coil spring, where as leaf springs have harmonic vibrations at different pitches depending on the length and spring rate of each individual leaf, thus causing axle hop. As mentioned, with the coil as a dampner on the leaf pack, speed and comfort are greatly improved. On the front end the same of course happens, also handling is improved to the point where the stabilizing bar may be removed if so desired.
Not to mention i have never heard so much rubbish as in the above statement.
Last time i checked axle hop was a phenomenon caused by geometry and poor damping under hard acceleration. Not to mention that leaves usually have better self damping qualities than coils due to interleaf friction. And saying that damping is improved the point where the sway bar can be removed????? What a top idea that is.
http://www.populationparty.org.au/
coil springs are well known for their dampening qualities.
I don't like slamming businesses but really, the claims they make for jamming coils into a leaf car are just so wrong I can't let it go.
apparently there's nothing that can't be fixed by jamming coils in there
Steve.
I don't like slamming businesses but really, the claims they make for jamming coils into a leaf car are just so wrong I can't let it go.
apparently there's nothing that can't be fixed by jamming coils in there
Steve.
[quote="greg"] some say he is a man without happy dreams, or that he sees silver linings on clouds and wonders why they are not platinum... all we know, is he's called the stevie.[/quote]
Posts: 3725
Joined: Wed Jun 30, 2004 1:45 pm
Joined: Wed Jun 30, 2004 1:45 pm
Location: Blue Mountains, or on a rig somewhere in bumf*ck idaho
got any literature that explains how that works? I'm not saying you're wrong, just that i've always heard that leaves are best at self damping and i can't see how a coil can self dampen? I'd like to know how that works.Gwagensteve wrote:coil springs are well known for their dampening qualities.
Steve.
http://www.populationparty.org.au/
Steve had his sarcastic pants on.rockcrawler31 wrote:got any literature that explains how that works? I'm not saying you're wrong, just that i've always heard that leaves are best at self damping and i can't see how a coil can self dampen? I'd like to know how that works.Gwagensteve wrote:coil springs are well known for their dampening qualities.
Steve.
Posts: 3725
Joined: Wed Jun 30, 2004 1:45 pm
Joined: Wed Jun 30, 2004 1:45 pm
Location: Blue Mountains, or on a rig somewhere in bumf*ck idaho
Who is online
Users browsing this forum: No registered users and 117 guests