Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
hi all
would like to know if there is anybody with info on doing a panhard/track bar on a rhd xj. i am about to do a RC 6.5" lift and the bar i received with the kit will not work on the right hand drive susp.
can i cut the upper joint off, drill and tap it to take a heim joint, modify the bracket to accept the heim or what (to make bar adjustable)?
i know that but would like to know what guys riding rhd's have done to overcome this as here in South Africa nothing is available and stuff has to be manufactured at the engineering or at home and just thought that there might be a good recipe to do it.
thx so far
steve
The best way around it is cut your old one in half and put left and right treads on it and a spacer ,make it about 4" long ,this will make it adjustable for you or do the heim joint but lot more work
thanks for info, will consider it
you don't perhaps have any pix of any RHD XJ's suspension lifts there in Aus. here we don't have that many and lifting them has actually just taken off so we are still a little in the dark here. I have looked and have only found one or two.
thx
Steve
the stock one wont droop far enough. you can get this stuff from "Wooders Garage". I had a RHD version of the Rubicon Express trac bar bracket made and used a tracbar from wooders.
