putting gq diffs under a hilux and have mounted the rear panhard according to factory nisssan measurements but it seems to me that it is too steep an angle with 2" coils in it (about 20 degrees) and will push the diff sideways on compression.
has anyone got pics of theirs with a lift in?
should i remake the mount to bring it closer to level? this would make it a very low hanging braket though.
any help or advise appreciated.
thanks in advance
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
another gq panhard question
another gq panhard question
Keep it shiny side up!
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
The theoretical ideal angle of the panhard when sitting static is horizontal; so as to minimise bump steer... this is not always possible, and in your case may look crap. But depending on your spring rate and ultimately your wheel up travel it might be best to have the mount slightly above the axle mount. I run a 4" lift in a GQ and the mount to the chassis is about 3-4'' above the mount on the diff housing...amd i still get a little bump steer.
I wouldnt be concerned with objects hitting the panhard if its close to horizontal because your wheels and axle have to clear this object firsy - offering protection to the panhard.
If your going to this effort i would definately consider an A-Frame rear end or triangulated 4 bar linkage either of which eliminate the panhard and give symetrical geometry on each side of your vehicle which is a huge benefit when selecting shock and spring lengths.
Cheers
Steve
I wouldnt be concerned with objects hitting the panhard if its close to horizontal because your wheels and axle have to clear this object firsy - offering protection to the panhard.
If your going to this effort i would definately consider an A-Frame rear end or triangulated 4 bar linkage either of which eliminate the panhard and give symetrical geometry on each side of your vehicle which is a huge benefit when selecting shock and spring lengths.
Cheers
Steve
want to do tri 4 but unsure whether it would pass engineers.
that and i havent done a tri 4 before and kinda unsure where to start.
do the lower links stay in stock position and the uppers are triangulated?
that and i havent done a tri 4 before and kinda unsure where to start.
do the lower links stay in stock position and the uppers are triangulated?
Keep it shiny side up!
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Who is online
Users browsing this forum: No registered users and 3 guests