Hoping someone has come up with a solution for DIY engine mounts... the genuine are getting VERY expensive! lol.
Or alternatively does anyone know of an engine mount from something else that fits... well actually I am initially chasing the under gearbox mount first
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Engine/Gearbox Mounts
Moderator: Tiny
Engine/Gearbox Mounts
94 Disco Tdi
Bar with Winch
Full Mesh Alloy Rack
Awning
2" Lift
Coolant Alarm, UHF
Dual Batteries
Snorkel
Bar with Winch
Full Mesh Alloy Rack
Awning
2" Lift
Coolant Alarm, UHF
Dual Batteries
Snorkel
Use a piece of old seatbelt to stop them breaking. There have been plenty of threads about this issue, IF search works. I think it's in the FAQs.
Try here: http://carl.outerlimits4x4.com/viewtopic.php?t=27237
Try here: http://carl.outerlimits4x4.com/viewtopic.php?t=27237
bru21 wrote:What happens in goat, stays in goat!
Its a very common problem - mostly on the torque side ( passenger ) but drivers side also does break so check it.
Its actually caused by poor design ( surprise surprise ) unlike a Vitara for example there is no specific torque control bush fitted so the engine/ trans mounts get twisted with the obvious outcome
When I went auto and reduction gears i added an extra torque reaction bush to eliminate the problem, getting it hard enough to control the twist but soft enough to not cause vibrations was a real challenge but worthwhile in the end.
As others have indicated - covered in many previous threads - seatbelt is the bush mechanics answer - and works for a stock setup.
The transmission mount also breaks occaisionaly so its worth doing also.
Before I changed to different mounts my record was 3 Passenger side, 2 Drivers side and 1 transmission mount in a year - not good.
However there is nothing I'm aware of that simply bolts straight in to fix the problem permanently every solution requires fabrication
Its actually caused by poor design ( surprise surprise ) unlike a Vitara for example there is no specific torque control bush fitted so the engine/ trans mounts get twisted with the obvious outcome
When I went auto and reduction gears i added an extra torque reaction bush to eliminate the problem, getting it hard enough to control the twist but soft enough to not cause vibrations was a real challenge but worthwhile in the end.
As others have indicated - covered in many previous threads - seatbelt is the bush mechanics answer - and works for a stock setup.
The transmission mount also breaks occaisionaly so its worth doing also.
Before I changed to different mounts my record was 3 Passenger side, 2 Drivers side and 1 transmission mount in a year - not good.
However there is nothing I'm aware of that simply bolts straight in to fix the problem permanently every solution requires fabrication
( usual disclaimers )
It seemed like a much better idea when I started it than it does now.
It seemed like a much better idea when I started it than it does now.
Who is online
Users browsing this forum: No registered users and 1 guest