Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 Series lift + tyres under 2100mm
Moderators: toaddog, Elmo, DUDELUX
80 Series lift + tyres under 2100mm
Hey guys,
I want to put a lift and bigger tyres under the 80 but I am limited to 2100 [garage door]. Any ideas what tyre and lift combo will give me height wise? The closer to 2100 without going over the better. Thanks for your time!
Cheers
Alby
I want to put a lift and bigger tyres under the 80 but I am limited to 2100 [garage door]. Any ideas what tyre and lift combo will give me height wise? The closer to 2100 without going over the better. Thanks for your time!
Cheers
Alby
Stock 'Cruiser X 2
www.dnaoffroad.com.au
www.dnaoffroad.com.au
Road Ranger
I have 4" lift an 35s, I think my springs have sagged a bit, but mine sits at around 2050mm
My UHF ariel on the bull bar is at 2100mm to the tip, If it touches going in to carparks, I wont go further. You cant always trust what the clearance signs say
Roof racks add about another 120mm, so you would get almost no lift with racks and be under 2100mm.
My UHF ariel on the bull bar is at 2100mm to the tip, If it touches going in to carparks, I wont go further. You cant always trust what the clearance signs say
Roof racks add about another 120mm, so you would get almost no lift with racks and be under 2100mm.
Thanks oldmate - yeah aware of some sagging over time..... Just how much is what im after...
oldmate wrote:4 inch springs and 33s were 2050mm
3 inch springs and 35s would be very close, maybe slightly less.
3 inch and 35s is the best combo in my opinion.
Most springs can sit .5 to 1 inch higher when they are new. they will take a few kays to settle in and shrink. so keep that in mind.
Last edited by DNA Off Road on Mon Sep 21, 2009 6:12 pm, edited 2 times in total.
Stock 'Cruiser X 2
www.dnaoffroad.com.au
www.dnaoffroad.com.au
No scrubbing with only 4"and 35's?
80's_delirious wrote:I have 4" lift an 35s, I think my springs have sagged a bit, but mine sits at around 2050mm
My UHF ariel on the bull bar is at 2100mm to the tip, If it touches going in to carparks, I wont go further. You cant always trust what the clearance signs say
Roof racks add about another 120mm, so you would get almost no lift with racks and be under 2100mm.
Stock 'Cruiser X 2
www.dnaoffroad.com.au
www.dnaoffroad.com.au
Ok thanks - do you know how wide the GXL rims are off hand?
80's_delirious wrote:very little scrubbing, occasionally when really crossed up, not enough to be a problem at all.
I have 315/57R16s on 8" rims. Previously had 33"s on 10 rims, the extra offset meant my 33"s scrubbed worse than the 35"s do
Stock 'Cruiser X 2
www.dnaoffroad.com.au
www.dnaoffroad.com.au
80 Height
5 inch lift, 35s, no body lift, no roof bars and I got 2075mm which is on par to most people. with 25mm clearance it makes 2100mm car parks scary and I hope they get their heights right.
Wife has dent in rear of her roof (Disco) from an air vent at the rear of a part though), woops
Wife has dent in rear of her roof (Disco) from an air vent at the rear of a part though), woops
Who is online
Users browsing this forum: No registered users and 3 guests