is there any differences?
in particular do the gu rears have a handbrake on them?
or is it on the transfer as on GQ?
otherwise will it bolt up?
could you just use the backing plates etc on gq housing?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
difference between gq and gu rear diffs and housings?
difference between gq and gu rear diffs and housings?
Keep it shiny side up!
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
GU diffs are about 40mm wider.
Diffs out of 4.8 litre Patrols have hand brake on the axle, all other models have them on the back of the gearbox.
There are also 2 different size GU rear diffs, the bigger diffs were fitted to manual 3l, 4.5l and 4.8l. Small diffs are same size as GQ diffs, just wider.
Tony
Diffs out of 4.8 litre Patrols have hand brake on the axle, all other models have them on the back of the gearbox.
There are also 2 different size GU rear diffs, the bigger diffs were fitted to manual 3l, 4.5l and 4.8l. Small diffs are same size as GQ diffs, just wider.
Tony
would the backing plates and calipers etc from a 4.8 patrol rear bolt to a gq housing?
using gq diffs in a conversion and dont have a handbrake at this stage just trying to work out a way of doing it.
using gq diffs in a conversion and dont have a handbrake at this stage just trying to work out a way of doing it.
Keep it shiny side up!
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Now doing general fab work and painting
trays, trailers, engine swaps on request, some tube work, silo section sliders, rust repairs, ute chops etc
Who is online
Users browsing this forum: No registered users and 0 guests