hi all,
got my dash all plugged in and screwed in and the whole right side of it doesnt work, speedo, fuel gage and it doesnt illuminate, just wondering if anyone has any ideas why?
thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
85 hilux dash
Moderators: toaddog, Elmo, DUDELUX
No you haven't.19richo90 wrote:hi all,
got my dash all plugged in
There's a few plugs to connect into the back of the instrument cluster. Pull it out and check that they're in PROPERLY
Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.
Dave
do you have to tweist it much, cause mine doesnt seem to twist that much, how do you know its in properly like will it cick in or anything?Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.
cheers
please clarify on that side
is the dash not working ie the guages not moving + no back light
or is it just no back light
if the former it could be a bad earth u could try a temporary earth and see if it starts working
is the dash not working ie the guages not moving + no back light
or is it just no back light
if the former it could be a bad earth u could try a temporary earth and see if it starts working
80 series 1980 hilux cab supra twin turbo engine
1hdfte 80 series
LHD fz 80 series GX
1hdfte 80 series
LHD fz 80 series GX
There's a little pin inside the plastic shroud. Depending on how much you've moved it already or how much it was knocked about whilst the dash was out you may have to twist the actual pin. It is round with a flat surface. This flat surface must line up with the flat surface in the back of the instrument cluster.19richo90 wrote:do you have to tweist it much, cause mine doesnt seem to twist that much, how do you know its in properly like will it cick in or anything?Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.
cheers
When it's in it should slide all the way on and click. If it's on and clicked it shouldn't slide back off without pushing the clip in.
If you think you've got it, give it a light tug.
I hope this make's sense.
Dave
l agree with canyonera 4x4 l had my dash apart put it back together everything worked but illumination if you've followed all the advice so far and no avial trace all your connectors using hilux repair manual
with my illumination not working the cause was the dimmer switch for lights which is just below the handbrake on the left side of steering wheel it was rusted and corroded pluggin it in blew fuses it was faulty trip to wreckers fixed it
with my illumination not working the cause was the dimmer switch for lights which is just below the handbrake on the left side of steering wheel it was rusted and corroded pluggin it in blew fuses it was faulty trip to wreckers fixed it
Who is online
Users browsing this forum: No registered users and 16 guests