Hi all
I'm currently in the middle of converting a FJ40 to a holden 308 v8, and i was wondering if there are any problems withusing the OEM thrust bearing with the new holden clutch.
The diameter of the OEM clutch thrust bearing/ throw out bearing (where it contacts the pressure plate) is slightly larger than the holden, but is the same length. The other problem with the holden thrust bearing is that its internal spline diameter is slightly narrower than the gearbox input shaft.
Using the OEM clutch thrust bearing/ throw out bearing also means that i can the use the existing clutch fork, so it would be preferable to use it, I'm just wanting to find out whether there are any problems that may be caused from doing so.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Clutch Question (FJ40 V8 conversion)
Moderators: toaddog, Elmo, DUDELUX
Who is online
Users browsing this forum: No registered users and 1 guest