hey i have a 90 model hilus it was originally 2.8 but now has a 2.4 turbo motor in it. the car runs (ran) fine and everything worked but i had to do a cab swap the cab i bought is the same and had a 2.8.
the guy left all the wiring in the cab but not engine bay but as ive gone to wire it up ive noticed some of its different but also alot of my harness looks like its been bodgied up.
anyway my question is are the 2.8 and 2.4 wiring harness the same?? as im going to see if i can find another harness ( just the engine bay part of it)
cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1990 hilux 2.8 / 2.4 diesel wiring harness
Moderators: toaddog, Elmo, DUDELUX
Will depend a lot on which 2.4 TD motor you have.
2LT will be pretty much the same, few more vacuum hoses for fuel pump, etc.
If the 2LTE, then a bit more wiring required as it will need the ECU to run properly.
2LT will be pretty much the same, few more vacuum hoses for fuel pump, etc.
If the 2LTE, then a bit more wiring required as it will need the ECU to run properly.
91' Hilux Surf with the usual mods & a few different ones ....
Coil SAS by www.budscustoms.com.au
Coil SAS by www.budscustoms.com.au
its the 2lt i looked at my mates hilux his is a 97 model 2.8 diesel and his wiring is the same as my original cab which originally had the 2.8 then had the 2.4 fitted and the new cab was definatley a 2.8 as well as it has 3l on the compliance plate.
did toyota change the way they wired them as my original cab is 11/90 and the new cab is 8/90.
im pickin up a wiring harness for it soon so i guess it should match with one of the two ive got
did toyota change the way they wired them as my original cab is 11/90 and the new cab is 8/90.
im pickin up a wiring harness for it soon so i guess it should match with one of the two ive got
thats what i thought at first because on my original cab some of the wiring was a bit bodgy. but after comparing them to my mates 2.8 its the new cab thats not even close to being the same and it looks like it has never been touched.
the cab i picked up has a voltage regulator in the engine bay. my original cab or mates cab dosent have one and the sensor on the brake booster is on top of the lid where as my original one and my mates one is on the bottom of the container where the fluid is held.
its got me F*&$%d there all 2.8s
the cab i picked up has a voltage regulator in the engine bay. my original cab or mates cab dosent have one and the sensor on the brake booster is on top of the lid where as my original one and my mates one is on the bottom of the container where the fluid is held.
its got me F*&$%d there all 2.8s
Who is online
Users browsing this forum: No registered users and 2 guests