Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

altinator good or stuffed, td42 gq

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 21
Joined: Tue Nov 03, 2009 9:15 pm
Location: Bargo nsw

altinator good or stuffed, td42 gq

Post by jem jem »

Hi all, just wonder wat volts should the altinator be charging at the battery>?? my gq is a 93 with 350k+ksIdle is at 12.8-13, full rpm IS ONLY 13.8 IS THIS CORRECT> if no wat is.. can get 2x different new altinators, one is a 9amp or there is a 120 amp one. $350-$550 :roll:
Posts: 2513
Joined: Sat Mar 05, 2005 1:14 am
Location: ingleburn

Post by familybus »

just disconnect your battery while its runnin and if it stalls then its stuffed! afaik
[color=lime][b]Im not a gyno but ill take a look at it for you![/b][/color]
God of Athiests
Posts: 8336
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

familybus wrote:just disconnect your battery while its runnin and if it stalls then its stuffed! afaik
And if is wasn't stuffed before, it surely will be after doing this....

Never run a vehicle without a battery connected to the alternator.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Posts: 326
Joined: Mon Aug 23, 2004 10:50 am
Location: Oran Park, NSW

Post by festy »

13v at idle, 13.8v at speed sounds ok.
Is that 13v at idle measured shortly after starting? If so, it may increase a bit after recharging the drain that cranking took out.
Check your battery voltage after it's been sitting overnight or longer - if it's around 12.6-12.7v then your alternator is charging it fine.
Posts: 21
Joined: Tue Nov 03, 2009 9:15 pm
Location: Bargo nsw

altinator

Post by jem jem »

Have dual battery in it had arb smart solinoid batterys both went flat after bout 2-3 weeks driveing 2hours to and from work everyday with the arb fridge hooked up and running on 1(lowest setting). thought solinoid was stuffed. so put a basic solinoid , sorta dose the same thing, turned the fridge off and it seems fine.....??? batterys are 1 year old heavy duty... :cry:
Posts: 326
Joined: Mon Aug 23, 2004 10:50 am
Location: Oran Park, NSW

Post by festy »

What's your fridge connected to, the aux or main battery?
Assuming the aux battery, not sure how the fridge could be flattening your main battery...

What's the current draw from both with everything switched off?
Posts: 270
Joined: Tue Jul 08, 2008 4:47 pm
Location: Burpengary.... Where the hell is that?

Post by Red Dog 4x4 »

Dose it have the vac pump on the back of it?

If not a GU 4.2 ( 100 amp ) will bolt on you just have to change the plug to a gu one or cut the plug off and put some spade conecterson and chage the fuse next to the main battery to a 100 amp fuse. Cost me $250 for a new one.
Posts: 21
Joined: Tue Nov 03, 2009 9:15 pm
Location: Bargo nsw

Post by jem jem »

vacume pump on rear.. can get a 90amp for 350 new or a 120amp for 550new.

ok , tryed a few things . driving home today. 12.9 put lights on 12.1-12.3 turn off 12.8-13.1-12.9 fridge has been off for 2days.....
Posts: 113
Joined: Sat Jul 12, 2008 8:59 am
Location: Sunshine Coast

Post by suggy126 »

Before buying a new alternator, try running a new heavier cable direct from your alt charge bort to the positive on your battery and see if your charge increeses, probably will. Patrol's never actually had a thick enough cable for the alternator and as they get older they get worse. I'm running 2B&S cable for mine because i now have a 120 amp alt on mine and i had the cable lying there, but ithink you'll see a voltage jump if you do run a heavier cable, 6 or 4 B&S should be heaps.
Posts: 21
Joined: Tue Nov 03, 2009 9:15 pm
Location: Bargo nsw

Post by jem jem »

i have heaps of 2b&s will try that thanks... the 120 amp good>???
] :roll:
Posts: 113
Joined: Sat Jul 12, 2008 8:59 am
Location: Sunshine Coast

Post by suggy126 »

Love it, i draw 80amps on high beam and it still keeps my batteries as 14v, only complaint is it doesn't start charging till 1500 rpm, but I'm aware of it so it's not a problem. Let me know how the charging circuit goes.
Posts: 1152
Joined: Mon Sep 25, 2006 8:25 pm
Location: the most livable planet in the universe

Post by its aford not a nissan »

your alt is fine , just the bodgey factory wiring is no good

run another cable from your battery though a fuseable link and to your alt ( ie: double up on your main chargeing wire ) , and there should be 2 more wires leave the white with red stripe wire in place and cut off the white wire leaving enough on the plug end to join another wire to it , then run this wire to your battery ,

this white wire is the voltage sense wire and on the factory loom it just joins into the charge wire 2-300 mm up from the alt , so it is sensing the voltage in this wire and not the battery , if you do get a bigger alt i would do this anyway as the bigger alt will need a bigger wire to make use of the extra amps
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests