hey all
i have a 93 80series T/D diesel
i dumb fucket at the moment....lol
anyway my brake pedal goes soft and right down to the floor when the motor in running.. when the motor is not running its hard..
i have change the master cylinder bleed it all ..
check the vacuum all great
put the pedal is still soft and goes right to the floor still...
do you guy think its the brake booster??? i don't know what else it can be...
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
brake problem
Moderators: toaddog, Elmo, DUDELUX
so it did it before you changed the master cyclinder?
I doubt it would be the booster, when a booster is gone you have to do all the work yourself i.e its very hard to push down - like the motor isnt running.
I would be looking for air in the system, or leaking slave cylinders.
take your wheels off and look at them for leaks or if your lazy and dont think its the problem you can just do this - but its messyer if it is a slave cylinder.
have a look at your resevoir, mark the level with a texta, start the engine and pump the brake pedal a few times, re check brake fluid level, if its lower it leaking, if its not lower then its not leaking.
in which case its air in the lines. describe how you bleed the lines?
I doubt it would be the booster, when a booster is gone you have to do all the work yourself i.e its very hard to push down - like the motor isnt running.
I would be looking for air in the system, or leaking slave cylinders.
take your wheels off and look at them for leaks or if your lazy and dont think its the problem you can just do this - but its messyer if it is a slave cylinder.
have a look at your resevoir, mark the level with a texta, start the engine and pump the brake pedal a few times, re check brake fluid level, if its lower it leaking, if its not lower then its not leaking.
in which case its air in the lines. describe how you bleed the lines?
*there's a rock, drive over it :) there's a bigger rock, drive over it :twisted: there's an even bigger rock, oops broke it :oops: Upgrade broken bit :bad-words:
Goto *
Goto *
Who is online
Users browsing this forum: No registered users and 14 guests