Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
spotties
Moderator: -Scott-
spotties
no you dont have to but definitly recomended.. most higher amp switches are only rated to 20amp where even a cheap relay is 40amps..most relays also have a pair of outputs so you can use one per spottie..forward facing spotties also have to be hooked up through headlight high beam unless they are covered by non-transparent covers .."legally".. use a minimum of 4mm cable{preferably 5mm} and run the earths back to a good solid point like the battery or thread under the bonnet.. dont skimp and earth to the bull bar or similar..make the positive fused from the battery and minimum of 5mm...also dont use "scotch locks", in a wet enviroment they're nothing but trouble, try and solder if posible... should only be an extra couple of bucks and small amount of time but they will be hassle free...
If at first you dont succeed.. get a bigger hammer
Who is online
Users browsing this forum: No registered users and 0 guests