G'day everyone.
Just got myself an 82 Range Rover the month.
Put it into 4wd for the first time the other week and now it seems as though it won't disengage 4wd (on roads it binds up around corners etc).
I'm assuming the centre difflock is staying in for what ever reason.
No matter what position I put the high/low selector or what posiition the centre diff lock lever is in it doesn't make a difference.
Any suggstion would be greatly appreciated.
Cheers,
Paul
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
82 Range Rover binding up
Moderator: Micka
Re: 82 Range Rover binding up
Range Rover is ALWAYS in 4wd, just high and low range, locked or unlocked centre diff. Sometimes you need to have the diff lock lever in unlocked and reverse straight back for a distance to get the centre diff lock to disengage.mistaboz wrote:Put it into 4wd for the first time the other week and now it seems as though it won't disengage 4wd
I like Salt
Thanks for the replies.
Have tried reversing for some distance and hasn't helped.
I did actually know that they are always in 4wd but must have had a dumb moment
It had sat there for about a year without any use, so I will replace the oil and see if it makes a difference.
Any other ideas?
Cheers,
Paul
Have tried reversing for some distance and hasn't helped.
I did actually know that they are always in 4wd but must have had a dumb moment
It had sat there for about a year without any use, so I will replace the oil and see if it makes a difference.
Any other ideas?
Cheers,
Paul
There is two air lines going to the front output cover on the transfer case that operate the difflock. I can't remember exactly how it works, but IFIRC engine vacuum pulls the diaphram which actuates a fork which slides a locking dog onto the centre diff. The fork slides along a short shaft with two detents locked and unlocked. The difflock light is operated by the fork being fully in the locked position irrespective of where the operating knob is.
Driving on hard surfaces can put enough load on the locking dog that the vacuum is not enough to release it.
A bit of compressed air into the lines may be enough but be carefull not to overdo it as the seals inside were only designed to take engine vacuum.
Next on the drivers side of the t.c. at the front where the diapfram is there is a cover plate remove and lever the locking collar free.
Driving on hard surfaces can put enough load on the locking dog that the vacuum is not enough to release it.
A bit of compressed air into the lines may be enough but be carefull not to overdo it as the seals inside were only designed to take engine vacuum.
Next on the drivers side of the t.c. at the front where the diapfram is there is a cover plate remove and lever the locking collar free.
out of my mind, back soon.
Who is online
Users browsing this forum: No registered users and 12 guests