I was wondering if anyone knew of someone who makes up bash plates for the underneath of 80 series cruiser?
Im dropping mine down from a 5inch to a 3inch, will I still be able to run 35's?
Dose anyone know where would be the best place to sell a set of 5inch superiour drop arms, I tried on this site but with no luck.
Many thanks in advance
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
suspension height and under body proyection for 80 series
Moderators: toaddog, Elmo, DUDELUX
3 inch should be fine for 35's. It may rub a little off road, but on road you should be right as far as cornering and steering go. As for selling the arms there are other 4wd forums you could try, or use ebay.
The worst part about being told you have Alzheimer's, is that it doesn't just happen once.
Im here for the sausage!
Who is online
Users browsing this forum: No registered users and 1 guest