Hey guys,
I am just wondering if anyone with an IRS paj could climb under and check a few measurements for me?
Basicly i am just wondering how different the bolting flange dimensions are for the rear and the front unit bearings. You know the 4 bolts that hold the bit on that the outboard cv goes through the 'splindle'. Mitsu run unit bearings as opposed to the likes of toy/nissan ifs that run a stub axle.
Any help much appreciated.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Help PLS -IRS unit bearing dimensions
Moderator: -Scott-
Help PLS -IRS unit bearing dimensions
WWW.TEAMDGR.COM
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
Re: Help PLS -IRS unit bearing dimensions
no one?
surely someone owns one.
surely someone owns one.
WWW.TEAMDGR.COM
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
WWW.SUPERIORENGINEERING.COM.AU
WWW.LOCKTUP4X4.COM.AU
Who is online
Users browsing this forum: No registered users and 0 guests