Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

this time its not the 4by

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 98
Joined: Thu May 01, 2008 4:37 pm
Location: goatsasspass

this time its not the 4by

Post by hollywood »

hey guys my suburbanite bitchuman crawler (XR6 BA falcon05) has a rattly cat cover on it and wont tighten up can i just take it off or will i need to put a new one back on cheers, steve
i dont naturaly look this bad work done it to me
Posts: 19062
Joined: Sat Oct 25, 2003 11:39 pm
Location: In a horse near you

Re: this time its not the 4by

Post by chimpboy »

hollywood wrote:hey guys my suburbanite bitchuman crawler (XR6 BA falcon05) has a rattly cat cover on it and wont tighten up can i just take it off or will i need to put a new one back on cheers, steve
I think you could safely throw the heat shield away but the usual go is to put a BF hoseclamp around them and get rid of the rattle that way.
This is not legal advice.
Posts: 2492
Joined: Sun Nov 24, 2002 8:57 pm
Location: Melbourne

Re: this time its not the 4by

Post by bazzle »

I would keep the shield. They get Sh!t hot.
Use the clamp method or a dop of weld as required.

Bazzle
Posts: 98
Joined: Thu May 01, 2008 4:37 pm
Location: goatsasspass

Re: this time its not the 4by

Post by hollywood »

clamp sounds good , s/steel one would be the best i would presume and yep it gets sh@t hot alright just ask my fingures :bad-words: lol, thanks guys cheers
i dont naturaly look this bad work done it to me
Posts: 458
Joined: Tue May 24, 2005 12:21 pm
Location: Brisbane

Re: this time its not the 4by

Post by Josh n Kat »

i usually give the heat shields a tap with a hammer or just tweak it with some pliers to distort it slightly.
sometimes works sometimes doesn't
Honey i cut the car in half!
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests