hi there i am going to be doing the 6g72 to 6g74 SOHC engine conversion (on a challenger) over christmas and was just wondering if somone could post a pic of the bracket that needs to be made up to cover the distributor hole.
OR if they can make 1 for me and receive a few $$ in the process I wouldnt mind
Thanks
Andrew.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3.0v6 to 3.5v6
Moderator: -Scott-
Re: 3.0v6 to 3.5v6
Its a pretty snug fit with an O-ring and all .. but I reckon a piece of 5mm flat plate and gasket goo\quality silicone would seal it up.
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Who is online
Users browsing this forum: No registered users and 0 guests