Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Hey Guys
Just wondering if anyone can help , I have a 95 single cab Hilux solid axle.
Have just purchased an original air con kit secondhand, and was wonder if anyone who has the same could tell me whereabouts in the wiring loom does the compressor pump plug into? if possible a pic would be greatly appreciated!
Cheers guys
thats the very same setup i have, i have all that alrady hooked up, but need to see the plug that wiring goes to in the loom near the fuse box.
Cheers sgc for actually going to the effort of taking photo's and posting them, your a champ!
1989 LN106- 2" spring lift, 285 mt117's, 4.8's, front spartan high pinion'd, 6000k H/L HID
OK, so I've had another look.. not much to photograph, unfortunately. The clutch / idle-up pigtail plugs into part of the loom right behind the battery which feeds up into the fuse/relay box. However, the two black/white and one red/white trace wires don't appear in the fuse box - they appear to go around the front of the car above the grille, then through the passenger side wing and into the cabin on the passenger side.
If I'd read the thread yesterday I could have taken some photos under the dash, I had it apart to get at the head unit
I assume those three wires are fused inline (unless there's a fuse compartment in the cabin anywhere?) and attach to the aircon switch / fan interlock.
Hope that helps...
[edit] This is the aircon page out of the Haynes book, probably not a lot of use but maybe you can make more sense of it than I can
Simon
'91 LN106R Hilux, 6ft tray, snorkel, 2" lift, probably more I haven't discovered yet
