Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Part time conversion for 100 series

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 12
Joined: Tue Jun 08, 2010 10:23 pm
Location: Bathurst

Part time conversion for 100 series

Post by LewisGQ »

Hi going with advice gained here and something I was thinking of doing to try and get better fuel consumption is the marks adaptors kit to make the car rear wheel drive for on road use is this something that can be done at home or is it a job for the mechanic and is there a noticeable difference in fuel consumption any info would be good thanks.
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Re: Part time conversion for 100 series

Post by Shadow »

Everyone i know that has done it has ended up saying the fuel decrease is marginal if any

There is less backlash in the driveline when taking off, gets rid of some clunkiness etc.

the only people who truly value the conversion is people with big lifts and very bad front driveshaft angless (105 or 80 cruisers)

if you have a 100series i think your wasting your time and money doing it, but thats just my opinion.
03 HDJ100R GXL / 94 FJ45-80
Posts: 1105
Joined: Wed Jan 23, 2008 8:56 pm
Location: central coast down under

Re: Part time conversion for 100 series

Post by stilivn »

No fuel savings, can do it at home but will need access to a press or take that piece to a shop. Will save you heaps on the install if you do it yourself but as said if your 4by is standard for the fuel saving you will get your better off with the safety of full time 4wheel drive.
1993 80 series, 4" tough dog adjustable bb lift kit, LPG, 35" MTR'S
brooksy wrote:Branden Tagg.....He is the King of all f@rkups & a Gimps bitch after hours
Posts: 745
Joined: Sat Aug 02, 2008 9:45 am
Location: Vanuatu/ QLD

Re: Part time conversion for 100 series

Post by thrashlux »

does your truck have ABS if it does
forget it as it wont work any more
too many legal hassels plus no saftey

is yours a 100 or 105 lots of people call their 105's a 100
if it is a 100 forget it
80 series 1980 hilux cab supra twin turbo engine
1hdfte 80 series
LHD fz 80 series GX
Posts: 1383
Joined: Tue May 06, 2008 8:12 pm
Location: Newcastle

Re: Part time conversion for 100 series

Post by oldmate »

The fuel savings are immeasurable.

Thrashlux is right about the abs. However the abs will work so long as you have the hubs on the front wheels locked, or just don't install the free wheeling hubs that come with the kit. You can save by not purchasing them at all.

Since you are doing this for the driveline clunk and not front end vibrations there's no reason you can't install the part time without the free wheeling hubs. The AVM hubs that get sold are rubbish anyway.

The handling change isn't that drastic. You will spin the wheels more in the wet, and may oversteer under power in corners in the wet. If you are not 100 percent sure, remove the front drive shaft, lock the center diff and drive it around like that for a few weeks. That will simulate a part time kit with no free wheeling hubs. (abs will still work).
Going full time to part time will require some adjustment to driving behavior, but it's very far from being unsafe.

I don't know what the deal is with the legal side of things. Modifications are normally allowed without certification if the modification matches the setup of a variation of the same model of car. For example base model 100's (technically 105 series) are part time 4wd. It's usually not the case for safety features, but full time 4wd is peddled as a safety feature more by marketing than science. If it were truly a safety advantage then it would be considered essential fitment along side other things like ABS and air bags.
The worst part about being told you have Alzheimer's, is that it doesn't just happen once.
Posts: 12
Joined: Tue Jun 08, 2010 10:23 pm
Location: Bathurst

Re: Part time conversion for 100 series

Post by LewisGQ »

Thanks to all for the info great help and yeah the car is a 105 with no abs didn't no there was much difference between the two any way I will take the front shaft out and see how it goes before spending any money.
Posts: 745
Joined: Sat Aug 02, 2008 9:45 am
Location: Vanuatu/ QLD

Re: Part time conversion for 100 series

Post by thrashlux »

LewisGQ wrote:Thanks to all for the info great help and yeah the car is a 105 with no abs didn't no there was much difference between the two any way I will take the front shaft out and see how it goes before spending any money.
sounds good

once you have made your decision can you let us know your results as so many people think it will make such a big fuel economy difference the more opinions the better

cheers
80 series 1980 hilux cab supra twin turbo engine
1hdfte 80 series
LHD fz 80 series GX
Posts: 1208
Joined: Fri Nov 08, 2002 8:21 pm
Location: sunshine coast

Re: Part time conversion for 100 series

Post by killalux »

The ABS is not an issue on the IFS 100 series, The pick up is off the rotor not the CV.

Steve
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS

LS1 STANDALONE HARNESS $475ex
Posts: 12
Joined: Tue Jun 08, 2010 10:23 pm
Location: Bathurst

Re: Part time conversion for 100 series

Post by LewisGQ »

Front shaft is now out and the movement from under the car has gone so much nicer to drive I will be doing the part time conversion as soon as I can and if the car gets any better fuel consumption well that will be a bonus. Once I have done the conversion I will post whether I get any better fuel consumption or not for those interested.
Posts: 291
Joined: Wed Jun 16, 2004 10:44 am
Location: Adelaide

Re: Part time conversion for 100 series

Post by sambo »

I recently did the part time kit on my IFS 100 series, fixed the clunk but no improvement in fuel economy.

I didn't believe that it would anyway but just good to confirm it.
05 Manual HDJ100R
84 HJ60 w/12HT, twin locked with longfields
Post Reply

Who is online

Users browsing this forum: No registered users and 105 guests