Any tips on removing a broken dowel that are busted under the surface of the flange on the hub?
Can you drill them out without damaging the dowel hole or are they hardened steel?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
remove busted hub dowels
Moderators: toaddog, Elmo, DUDELUX
Re: remove busted hub dowels
hardend
Re: remove busted hub dowels
You can drill hardened steel. You'll need a diamond tip bit and keep it lubricated as it gets real hot. If it's not rusted up bad you could probably drill a small hole and use an easy out, otherwise drill it right out and put a tap through.
The worst part about being told you have Alzheimer's, is that it doesn't just happen once.
Re: remove busted hub dowels
Can you drill new dowel positions rotated around from the originals and just drill straight through the axle flange then insert new dowel ?
Who is online
Users browsing this forum: No registered users and 0 guests