Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Engine swaps

Tech Talk for Jeep owners.

Moderator: GUtripper

Post Reply
Posts: 5256
Joined: Fri Jun 16, 2006 6:49 pm
Location: Melbourne

Engine swaps

Post by Struth »

Hi guys, Toyota man here :oops:

I am doing some research and need to find out what are common engine swaps for Jeeps.

Need to know what you guys upgrade with and which ones are most effective.

Thanks in advance.
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Re: Engine swaps

Post by MightyMouse »

For JK's a commonly available conversion is the fitting of one of the range of Chrysler Hemi V8's.
From my limited knowledge of these swaps.... there are a range of engines and states of tunes and are readily engineered ( if done properly ).
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Posts: 1918
Joined: Fri Aug 26, 2005 4:28 pm
Location: Melbourne

Re: Engine swaps

Post by GUtripper »

I have seen a few TJ's with Gen 3's, 6 litres etc. There is a XJ with a 5.7 chev in it in WA just done.

The 4.0 six in either XJ's or TJ's takes well to stroking, kits and bits are readily available to take them to 4.7l, 200+kw.

Older rigs (CJ's) have been fitted with everything from AMC V8's to Holdens to Chevs and Ford V8, even Crysler V8's.

With the JK's, Hemi's are the go. Everything is available in US, or here via Pro-Comp / AEV in Melb.
My friends aren't holding me back..... I'm pulling 'em forward.
Posts: 5256
Joined: Fri Jun 16, 2006 6:49 pm
Location: Melbourne

Re: Engine swaps

Post by Struth »

Thanks guys, do drivelines normally need upgrading too?
Posts: 399
Joined: Mon Nov 25, 2002 5:29 pm
Location: Sydney

Re: Engine swaps

Post by AussieCJ7 »

Struth wrote:Thanks guys, do drivelines normally need upgrading too?

Way too broad a question

What jeep and drive line currently installed and what engine you think of ??? You can mix and match almost anything on a Jeep so better to start with what you have and your build ideas than a broad question :drinking:
Posts: 5256
Joined: Fri Jun 16, 2006 6:49 pm
Location: Melbourne

Re: Engine swaps

Post by Struth »

AussieCJ7 wrote:
Struth wrote:Thanks guys, do drivelines normally need upgrading too?

Way too broad a question

What jeep and drive line currently installed and what engine you think of ??? You can mix and match almost anything on a Jeep so better to start with what you have and your build ideas than a broad question :drinking:
Broad question looking for a broad answer such as (Cjs needs diffs and or trans upgraded when stepping up to a Hem I, or D40s will not last long behind a 350 or similar v8, but D60s will handle v8 power)
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Re: Engine swaps

Post by MightyMouse »

With a Hemi conversion transmission / transfer and driveline may all be issues depending on state of tune and driver behavoirs.

D60 conversions aren't that uncommon of JK's with stock engines / drivelines as D30's are just adequate for standard use, D44's are a little better but for the potential torque increase of a Hemi
probably better to look at thw D60 path if serious off road use being considered.
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Posts: 83
Joined: Sat Aug 23, 2008 8:23 am
Location: Jimboomba

Re: Engine swaps

Post by Gaza520 »

Just reading some of your posts and as i want to use the jeep for a tow car i was looking at fitting the turbo 2H diesel from my cruiser. What can of worms would i be opening to fit it and use the jeep auto. cheers. its a 95 cherokee
Posts: 46
Joined: Mon Feb 14, 2011 8:52 pm

Re: Engine swaps

Post by 4wheelinls1 »

I think that is what is referred to as going backwards. Less power, no way to engineer due to vintage of the engine.

Joel
4B Fabrications & Perfomance Tuning
1/12 Industry Blvd.
Carrum Downs
http://www.4bfabrications.com.au" onclick="window.open(this.href);return false;
Posts: 1213
Joined: Wed Oct 26, 2005 8:25 pm
Location: SE Melbourne

Re: Engine swaps

Post by dank »

What are you plannign on towing? We have a XJ that easily tows a 2.5T trailer rig and trailer through the hills and on the flat. THey are rated to 3T but I reckon thats a stretch. The standard 4.0L does the job fine. why you'd want to put a 2H into an XJ is beyond me.
Work - KPD4X4.COM - KPD Industries Australian Distributor of Diesel Power Modules - Germany.
Play - dank's zook
Posts: 83
Joined: Sat Aug 23, 2008 8:23 am
Location: Jimboomba

Re: Engine swaps

Post by Gaza520 »

The thing i was worried about was engine temp and fuel usage and comp truck is 1.9t so with the car trailer would be on its 3T limit just that its a good little car to drive
Posts: 399
Joined: Mon Nov 25, 2002 5:29 pm
Location: Sydney

Re: Engine swaps

Post by AussieCJ7 »

The problem with XJ towing 3T is not the engine

you have a mid size wheel base a small D35 real axle and monoque construction so the trailer ends up steering the XJ

If you want to tow 3 T regularly and want a Jeep then a FSJ is the choice standard with a 360 V8 and plenty of weight to tow well, if you dont want a Jeep then GQ or GU patrol would be my pick

But if it just the odd around the corner to a local track then the XJ will do a great job up to its limit
Posts: 41
Joined: Thu Jul 27, 2006 12:22 am
Location: sydney

Re: Engine swaps

Post by wolfmeister »

AussieCJ7 wrote:The problem with XJ towing 3T is not the engine

you have a mid size wheel base a small D35 real axle and monoque construction so the trailer ends up steering the XJ

If you want to tow 3 T regularly and want a Jeep then a FSJ is the choice standard with a 360 V8 and plenty of weight to tow well, if you dont want a Jeep then GQ or GU patrol would be my pick

But if it just the odd around the corner to a local track then the XJ will do a great job up to its limit
psst........ dont tell wooders :smilecolros:
I may be dumb, but im ugly too
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest