trouble getting out of 4x

Post by **grumpy221** » Sun Apr 18, 2004 7:43 pm

hey guys anyone ever have any trouble getting a 91 pajero out of 4x? I can select 2x but the thing stays in 4x ......even after turning off I have to go in reverse and be a bit rough with it before it will disengage any help would be appreciated. :?:

Post by **Bitsamissin** » Sun Apr 18, 2004 7:55 pm

Are you refering to the dash lights indicating you are still in 4x4 but the lever is in 2wd ??
Remember the super select is still a mechanical t/case and wherever the t/case lever is that is what range you are in. If the lights on the dash say otherwise there is most likely an electrical/vacuum issue.
This problem has also been well covered in prior threads you can check out.

Post by **grumpy221** » Sun Apr 18, 2004 8:25 pm

no the thing is still in 4x front hubs locked and all....

Post by **panyajero** » Sun Apr 18, 2004 9:09 pm

have that problem with my 93 Jabber. Rang Mitsubishi, and thats normal apparently. Just have to either put it in reverse and back to neutral, or roll foward and put it in neutral. Found the second one works best.

A whole lot of swearing goes a long way when in doubt.

Post by **grumpy221** » Sun Apr 18, 2004 9:19 pm

last time coming off bribie beach had damm thing locked in ..had to drive 5kms then it let go .......now I know the meaning of wheel windup

Post by **awbeattie381** » Wed Apr 21, 2004 1:26 pm

grumpy221 wrote:last time coming off bribie beach had damm thing locked in ..had to drive 5kms then it let go .......now I know the meaning of wheel windup

what was the end result?

Post by **Noisey** » Wed Apr 21, 2004 1:39 pm

windup

Post by **Monty** » Wed Apr 21, 2004 2:16 pm

You will probably find your linkages are broken somewhere and not engaging back into 2wd.

Solution is to get under your truck have a good look moving around the selctor and work out if its all working. You will probably find that a linkage aint engaging properly for some reason and fix what is wrong with it. My mate just chucked some washers in mine to fix up part of a broken linkage to get it to its original height and it goes in and out of low range with no problems

Post by **grumpy221** » Wed Apr 21, 2004 2:29 pm

ok shall have a look at the linkages thanks for the tip...... seems to go in alright lights go on but different when returning to 2wd lights dont go out till it is 2x

Post by **grumpy221** » Wed Apr 21, 2004 2:31 pm

what was the end result?[/quote]

it went back into 2x after awhile

Post by **grumpy221** » Sun Apr 25, 2004 1:34 am

allso the c/d light "flickers" anyone got that problem??? or is it a low oil sensor?

Outer Limits 4x4 Board

trouble getting out of 4x

trouble getting out of 4x

Who is online