Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

shaving diff housing

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 44
Joined: Mon Aug 04, 2008 7:00 pm
Location: melbourne

shaving diff housing

Post by some_guy »

got a question for those that have shaved there diff housings before, the front in particular
picked up a new housing to replace my bent one so before i put it in i'm going to brace and shave it

what did you do with the drain plug? where is the best place to put the new one after the shave has been completed?

thanks
Glenn
Top
Posts: 779
Joined: Tue Sep 02, 2003 8:17 pm
Location: Penrith, N.S.W

Re: shaving diff housing

Post by markil »

I just replaced the 2 lowest diff studs with bolts and use them for draining the oil.
Mark.
Top
Posts: 135
Joined: Tue Nov 20, 2007 9:26 pm
Location: Maitland

Re: shaving diff housing

Post by niss50 »

How did you work out how much you can cut off the housing.
Top
Posts: 297
Joined: Thu Jan 20, 2011 1:48 pm

Re: shaving diff housing

Post by 91Mav »

Leave a few mm of clearance to the crown wheel. Go 8mm plate
Top
Posts: 44
Joined: Mon Aug 04, 2008 7:00 pm
Location: melbourne

Re: shaving diff housing

Post by some_guy »

markil wrote:I just replaced the 2 lowest diff studs with bolts and use them for draining the oil.
cheers mark, was one of the many ideas i'd come up with.
now to start cutting :twisted:
Top
Posts: 411
Joined: Tue Feb 24, 2009 11:00 am
Location: Katherine N.T

Re: shaving diff housing

Post by gu town »

Theres a thread somewhere on here about shaving diffs.

Whoever did it cut off "too much" , welded the plate on then heated and bashed the plate till the crownwheel had clearance... food for thought.
GU td42 ute with go fast bits and go futher bits
Top
Posts: 187
Joined: Sat Jan 26, 2008 10:46 am
Location: Australia

Re: shaving diff housing

Post by MikeH »

I would have cut a slot in it to clear the crownwheel then weld a second smaller plate over the top.
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 65 guests