Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Interchangable Input flanges?????

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Forum rules
Post Reply
Posts: 766
Joined: Mon Dec 30, 2002 3:08 pm
Location: Melbourne

Interchangable Input flanges?????

Post by jtraf »

Hello all,

just wondering whether the input flange from an 82 1lt transfer case
is interchangable with the input flange of a later model 1.3lt transfer case?

cheers

James
Top
User avatar
Guy
Posts: 10366
Joined: Thu Dec 12, 2002 8:43 am
Location: Wangaratta

Post by Guy »

Yep it is .. best to get a new staked nut .. but mine have been off and on a few times now .. just use a bit of locktite on em .. They are also very f@#king tight, I normally run it down to my local tyre place and use thier rattle guns to get the nuts off and do em up again ..

Guy
Top
Posts: 2031
Joined: Tue Oct 22, 2002 10:49 am
Location: On a mission...

Post by Damo »

If the flanges have been on there for a while they might be a tad difficult to get off. The ones on my original case took 10 mins each to get the flanges off (after the nuts were removed) and that was with a puller & rattle gun!!!
Top
Posts: 3443
Joined: Tue Oct 29, 2002 10:50 pm
Location: Currently On the Road !!

Post by Dozoor »

As above thery are all interchangeble but remember there is three different flange bolt patern sizes , 1 ltre smalest ,1.3 narrow track med ,1.3 wide track large. This is somthing to watch for when buying drive shafts ,I have been caught Brought a shaft that had a front large and rear med ,Chucked a fit when i needed to use it !! :x
Larry.
Top
Post Reply

Return to “Suzuki”

Who is online

Users browsing this forum: No registered users and 19 guests