Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

need to fab longer pushrod on slave unit in lux 308 convers

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 1544
Joined: Fri Jan 03, 2003 10:33 am
Location: Wahgunyah(REDNECK WONDERLAND) Victoria

need to fab longer pushrod on slave unit in lux 308 convers

Post by Webbie »

Just put a new clutch slave cylinder in but i cant get enough travel out of it to allow me to change gears. :roll: I thought of making a longer pin but then on the same token dont want the bearing rubbing , on the clutch fingers anyone got any ideas.83lux with 308 convers.
Lockers or Knockers ,both will make for fun.

HYBRID 4B PRDUCTS Visit Tigerz11 here http://www.tigerz11.com.au/ and LOCKTUP 4x4 here http://www.locktup4x4.com.au/ cheers

www.trailtrack4x4.com
Top
Posts: 1084
Joined: Sun Apr 04, 2004 9:33 pm
Location: Aotearoa

Post by J Top »

Hi Webby
Marks adp make a sleeve to reduce the size of the gq slave in the chev conv.This gives the slave more travel.
Can you fit a smaller bore slave or a larger bore M/C.
Normally a longer push rod wont fix it ,unless the slave is coming to the end of it's travel,ie mounted too far away.
J Top
Top
Posts: 1242
Joined: Fri Oct 17, 2003 8:50 pm
Location: Kanwal

Post by ZOOK60 »

try dellows automotive in sydney they had everytheing i needed
P.E.T.A
People eating tasty animals.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests