Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

oxy blunder

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 275
Joined: Sun Oct 05, 2003 10:32 pm
Location: Sunniecoast

oxy blunder

Post by scorched »

Was cutting of shackle mounts and it melted the chassis.

How do u think i should fix it or will it be right to just weld shackles back again.

Pics

cheers christian
Gq patrol
Top
Posts: 964
Joined: Mon Jun 02, 2003 6:58 pm
Location: brisbane

Post by bj56 »

fark how did u manage that i would be welding in some plates befor putting the shackles back on
Top
Posts: 151
Joined: Thu Dec 04, 2003 6:37 pm
Location: Springwood NSW

Post by Eddywelder »

looks like you got a little carried away there.....I`d say clean it all up neatly and plate it back up to close it off...then reweld your hanger back on...
there are special gouging tips you can use for jobs like this they are a cutting tip but have a 45 degree bend in them ideal for repair work and cuttuing thru welds but are not cheap....I know it was a bastard when I cut my rear hangers of but you have to know where to cut and where not to cut ,I used a small angle grinder and those factory welds are very strong
Last edited by Eddywelder on Sun Jul 04, 2004 4:49 pm, edited 1 time in total.
Top
Posts: 2820
Joined: Sun May 25, 2003 10:04 am
Location: Redbank Plains, QLD

Post by Daisy »

Nasty :shock:

Weld some plates on then put shackles on.

I wouldnt trust the strength of chassis atm without plates and puttin shackles on
Top
Posts: 3924
Joined: Mon Oct 21, 2002 10:35 pm
Location: Newcastle NSW

Contact:
Contact hypo

Post by hypo »

fold a peice of plate up like a U shape and weld it back on..

just weldin flat plate on the bottom wont b any good
:finger: HYPOFAB :finger:

Thanks to:

Polyperformance
Yuri 4x4
Longfield
Top
Posts: 275
Joined: Sun Oct 05, 2003 10:32 pm
Location: Sunniecoast

Post by scorched »

U shape seems to be the go. Cheers
Gq patrol
Top
Posts: 943
Joined: Thu Jul 31, 2003 8:23 pm
Location: Darwin

Post by Tojo »

sometimes its better to use a cutting disc on the grinder to cut the welds then use a cold chisel to brake the old mounts off. Be carefull to clean it up before you plate it as it will be a potential rust problem in the future.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests