Hey fellas
I need a set of flares for my 4 dr rangie, i also want to cut the guards out to fit bigger tires, I know graeme cooper auto has a kit for cut out guards but it costs $545 does anyone know of another alternative
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
flares
Moderator: Micka
I put 40mm unistrut brackets between the guard and the body at the corners of the guards so the guard was flared outward by the brackets. I also then with my bare hands flared the guard out around the circumference. 
Pat,
Brisbane, Australia,
JK 4door Rubicon, currently 4 Sale :(
It's a Jeep thing, I don't understand........
Brisbane, Australia,
JK 4door Rubicon, currently 4 Sale :(
It's a Jeep thing, I don't understand........
If you're not too concerned about cosmetics, start cutting!
I've cut my guards up to the same level as the inner wheel arch and i'm planning on screwing the rubber flare to the inner wheel arch, sticking out past the outer guard.
The rear is another matter. You have to cut your rear doors!
The outer skin is easy, being aluminium, but the inner skin is steel. You'll also need to fill the gap, unless you want LOTS of mud and water in your doors!
Making it look good can be tricky, but if you're patient, you can really make the flares look good, and kinda factory looking!
BTW, I too would like to see anyone's pics on cutting front guards and rear quarters/door to fit bigger rubber, and to fit flares.
I've cut my guards up to the same level as the inner wheel arch and i'm planning on screwing the rubber flare to the inner wheel arch, sticking out past the outer guard.
The rear is another matter. You have to cut your rear doors!
The outer skin is easy, being aluminium, but the inner skin is steel. You'll also need to fill the gap, unless you want LOTS of mud and water in your doors!
Making it look good can be tricky, but if you're patient, you can really make the flares look good, and kinda factory looking!
BTW, I too would like to see anyone's pics on cutting front guards and rear quarters/door to fit bigger rubber, and to fit flares.
Who is online
Users browsing this forum: No registered users and 3 guests