Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Grease Nipples
Moderator: Tiny
Grease Nipples
Hey how does everyone grease up the uni joints on the drive shafts? theres about four of them but the nipples are angled so that it's near impossible to get the gun in there. I tried turning the shaft for a better angle but to no avail.
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...
Initially you might have to remove the driveshaft to access the nipples, as they can block with crud and make it difficult to pump with grease, then once they are cleared, you should be able to grease them with the shaft rotated enough to give you straight access. if the grease is just pumping out the side of the gun head, you might have a faulty seal in the gun head.
Built, not bought.
?
I thought the nipples talk might get a mixed response.....
think i'll just get some 90 degree nipples and screw them in. doesnt look like mine has ever been done....
think i'll just get some 90 degree nipples and screw them in. doesnt look like mine has ever been done....
Who is online
Users browsing this forum: No registered users and 2 guests