Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Beadlocked rims drawings or info
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Minion #1
Minion #1
Minion #1
That picture is exacly what I have done both plates were made out of 6mm plate I firstly marked them out then used a oxy to cut out the 2 rings tack welded them together in 4 places then drilled the holes the correct size for a 10mm tap I taped 4 holes so I could bolt them together and put them on a lathe to machine the inner and outer diameters then finished of the rest of the threaded holes the outside diameter is exactly the same size as a 15 inch rim sat it on top and tacked it in 4 places them stich welded it on so as to minimunize worpage to easy and it cost nothing will post some photos when a mate can get over here with his digital camera
Who is online
Users browsing this forum: No registered users and 3 guests