Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Bigger tank

Tech Talk for Rover owners.

Moderator: Micka

Post Reply
Posts: 264
Joined: Tue Aug 31, 2004 4:57 pm
Location: New Zealand

Bigger tank

Post by Rotazuk »

Hi
Thinking about a bigger tank for long trips etc . Was wondering if anyone made a bigger tank to take up the extra room made by a 2 in body lift .
Seems better to move the top of the tank up rather than down .

Cheers
Chris
Posts: 58
Joined: Mon Sep 13, 2004 2:33 pm
Location: bogged in the backyard only track stiil open

bigger tank

Post by trr35l »

i have a tank that sitts in the back of a rangie classic inside behind the rear seat or as i did in my patrol get some ply wood get under the thing and make a tank filling all the room and get a sheet metal joint to make you one i got about 60 extra litres by filling the room better and going up the 50mm for the body lift with the tank no futher down than the factory one
rover gone zook here i come
Posts: 181
Joined: Sun Aug 22, 2004 4:37 pm
Location: melbourne

Bigger tank

Post by swamp »

Chris
I thought you might be able to get another tank from th wreckers , cut it horiziontaly above the seam line , cut your tank 50mm or so up from the seam line weld top of the new one on the base of the old one , get it pressure tested and voila.
Or the after market will build one for $$$.
Regards
Michael.
out of my mind, back soon.
Posts: 264
Joined: Tue Aug 31, 2004 4:57 pm
Location: New Zealand

Post by Rotazuk »

Hi
Since I can't find on I was planning on slicing one in half and extending it etc . A little busy at the mo but will get to it next year .

Cheers
Chris
Posts: 100
Joined: Mon Jun 23, 2003 9:05 pm
Location: Rosvale Qld (south of 'Switch)

Post by mu-stu »

I've heard there are sill tanks too for the Rangie. Not sure where they are available from though. Anyonje else know? :roll:
2003 4.7lt V8 Jeep Grand Cherokee Laredo
1981 3.5ltr 2dr Range Rover
------------------------------------------
Welcome to Australia - the nanny state!
Posts: 2384
Joined: Mon Mar 31, 2003 10:05 am
Location: Brisbane or 169.254.243.241

Post by RaginRover »

Howdy all,

If you change the tanks setup in the car you will need to get a mod plate
to keep it all legal. Just keep it all in mind guys

Tom
Posts: 1559
Joined: Sun Nov 03, 2002 2:35 pm
Location: Captain Creek QLD

Post by Bush65 »

mu-stu wrote:I've heard there are sill tanks too for the Rangie. Not sure where they are available from though. Anyonje else know? :roll:


I got mine from Long Range Automotive in VIC
John
Posts: 1767
Joined: Wed Jun 04, 2003 9:30 am
Location: Just Near Fraser Island

Post by Maggot4x4 »

Bush65 wrote:
mu-stu wrote:I've heard there are sill tanks too for the Rangie. Not sure where they are available from though. Anyonje else know? :roll:


I got mine from Long Range Automotive in VIC


What were they worth?
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
Posts: 1559
Joined: Sun Nov 03, 2002 2:35 pm
Location: Captain Creek QLD

Post by Bush65 »

Maggot4x4 wrote:
Bush65 wrote:
mu-stu wrote:I've heard there are sill tanks too for the Rangie. Not sure where they are available from though. Anyonje else know? :roll:


I got mine from Long Range Automotive in VIC


What were they worth?


Sorry it was too long ago. I bought a stainless water tank for one side and a steel fuel tank for the other side.
John
Posts: 82
Joined: Wed Sep 10, 2003 4:14 pm
Location: Sydney

Sill Tanks

Post by Rangee »

i have a set of sill tanks for sale .... they hold 45 ltrs each ...
make me an offer
cheers
Rangee
Virgins !!!
someone has to go first !
Posts: 139
Joined: Thu Feb 05, 2004 9:58 pm
Location: Following that pushbike in Qld

Post by Rangie Wrecker »

I have a custom made alluminium tank built to fit a 2" body lift but I can't use it at the moment as there are two LPG tanks in it's place. I have a Long Range Automotive sub tank for petrol that sits behind the drivers side rear wheel and fills via the original fuel tank filler position as well as two custom made alluminium sill tanks with a transfer pump that empties either sill tank A or B back into the sub tank at the rear via a two into one selectable fuel solinoid valve. Best of both worlds heaps of petrol and LPG.
Salad is not food, salad is what food eats.

"Hit pay dirt with KDRT"
Posts: 1767
Joined: Wed Jun 04, 2003 9:30 am
Location: Just Near Fraser Island

Post by Maggot4x4 »

Rangie Wrecker wrote:I have a custom made alluminium tank built to fit a 2" body lift but I can't use it at the moment as there are two LPG tanks in it's place. I have a Long Range Automotive sub tank for petrol that sits behind the drivers side rear wheel and fills via the original fuel tank filler position as well as two custom made alluminium sill tanks with a transfer pump that empties either sill tank A or B back into the sub tank at the rear via a two into one selectable fuel solinoid valve. Best of both worlds heaps of petrol and LPG.
3

Are you selling the sill tanks and rear sub tank?
[quote="Wooders"]If ya want a 4x4 camry go ahead & buy a Patrol or Cruiser.[/quote]Rangie with 80s LC diffs, Isuzu 4bd1, Twin ARB lockers, 8000lb Hi mount warn, 315x75x16 Procomp XTerrains
Posts: 139
Joined: Thu Feb 05, 2004 9:58 pm
Location: Following that pushbike in Qld

Post by Rangie Wrecker »

Maggot4x4 wrote:
Rangie Wrecker wrote:I have a custom made alluminium tank built to fit a 2" body lift but I can't use it at the moment as there are two LPG tanks in it's place. I have a Long Range Automotive sub tank for petrol that sits behind the drivers side rear wheel and fills via the original fuel tank filler position as well as two custom made alluminium sill tanks with a transfer pump that empties either sill tank A or B back into the sub tank at the rear via a two into one selectable fuel solinoid valve. Best of both worlds heaps of petrol and LPG.
3

Are you selling the sill tanks and rear sub tank?


Sorry for the misunderstanding but no I'm not.
Salad is not food, salad is what food eats.

"Hit pay dirt with KDRT"
Posts: 142
Joined: Mon Nov 10, 2003 6:36 pm
Location: Vic

Post by Rovernaut »

My Disco is Dual fuel, It has 2 scuba tanks were the Original petrol tank was and a 45 litre tank for petrol tucked up inside the rear quarter panel near where the fuel filler cap is.
Why couldn't you fit one of those tanks there? and gain an extra 40 litres. Ot get one each side and have a tranfer pump from them?
Posts: 42
Joined: Mon Nov 01, 2004 1:16 pm
Location: N QLD

Post by hook »

Rangie Wrecker
I have a custom made alluminium tank built to fit a 2" body lift but I can't use it at the moment as there are two LPG tanks in it's place. I have a Long Range Automotive sub tank for petrol that sits behind the drivers side rear wheel and fills via the original fuel tank filler position as well as two custom made alluminium sill tanks with a transfer pump that empties either sill tank A or B back into the sub tank at the rear via a two into one selectable fuel solinoid valve. Best of both worlds heaps of petrol and LPG.


How much did it cost to get the Alluminium tanks bulit.

Just put a 150lt Davis tank in the Disco and it's about 30 kg empty.
let alone putting 2 sill tanks.
98 TDi Disco

N QLD
Posts: 1
Joined: Thu Dec 30, 2004 8:18 am

Post by Country Lad »

RaginRover wrote:Howdy all,

If you change the tanks setup in the car you will need to get a mod plate
to keep it all legal. Just keep it all in mind guys

Tom


Depends on what you do as to whether it needs to be mod plated. Seems many just mod plate stuff that don't need be.

The Light Vehicle Code of Practice January 1994 states "if a replacement tank of a larger capacity employs the OEM mounting system, then installation must be shown by engineering certification to be adequate."

So reading that as it is, mount it differently but use the same space don't need it mod plated saving yourself some dollars. ;)

If in doubt contact the RTA technical services but they are fairly relaxed with modifications if you read things the right way. Just don't use unsound engineering practice and you should be okay. :D
Posts: 29
Joined: Tue Nov 09, 2004 1:59 pm

Post by kurmit »

Yes have and can supply a 115 liter tank that is desined to take up the room created by [utting in a 50mm boddy lift and it dosent protrude bellow the chasis
A & J racing
Post Reply

Who is online

Users browsing this forum: No registered users and 19 guests