Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Triton Turning Circle
Moderator: -Scott-
Triton Turning Circle
As we all know the Triton's have a lousy turning circle. An unfortunate failing. Anyone out there have any solutions or suggestions?
2000 Triton GLX Dualcab, Bullbar, Hella Rallye 4000's, Flares, BFG AT's
www.4wdaus.com
------------------------------------------------------
www.4wdaus.com
------------------------------------------------------
Adjust the steering stops so that the wheels can get closer to the chassis rails, works especially well if you've got relatively narrow tyres. there usually is a little extra available available.
might mean that you will get a little rubbing in extremes with hard lock on offroad, but u get that.
Rob.
might mean that you will get a little rubbing in extremes with hard lock on offroad, but u get that.
Rob.
96 Paj 2.8 TD 2" lift, Snorkel, LR Tank, Dual Batt, winch, 32 MTRs, RT tent and rack, polyairs etc
Thanks for all the comments to date. I like the pedal to the metal into corners proposition, although it can get a bit hairy in car parks 
I have heard that the steering stops can be adjusted. I was speaking to a Mitsubishi sales guy who reckoned that they should be adjusted already - supposed to happen before the Tritons leave the showroom. But some dealers get lazy and don't make the adjustment. So I have to work out whether mine have been adjusted or not. It's hard to know just how bad is bad when talking of a Tritons turning circle.
I am not sure what the definition of a narrow tyre is. I am running BFG AT's 31 x 10.5 X 15's on CSA 15 x 7 rims. I certainly wouldn't want any narrower!!! At full lock I still have some clearance, but not much.
Anyway thanks again.
Cheers
Steve
I have heard that the steering stops can be adjusted. I was speaking to a Mitsubishi sales guy who reckoned that they should be adjusted already - supposed to happen before the Tritons leave the showroom. But some dealers get lazy and don't make the adjustment. So I have to work out whether mine have been adjusted or not. It's hard to know just how bad is bad when talking of a Tritons turning circle.
I am not sure what the definition of a narrow tyre is. I am running BFG AT's 31 x 10.5 X 15's on CSA 15 x 7 rims. I certainly wouldn't want any narrower!!! At full lock I still have some clearance, but not much.
Anyway thanks again.
Cheers
Steve
2000 Triton GLX Dualcab, Bullbar, Hella Rallye 4000's, Flares, BFG AT's
www.4wdaus.com
------------------------------------------------------
www.4wdaus.com
------------------------------------------------------
Nope, not joking. But this is only what I had been told by a sales guy. I posted here in the hope of finding out more from people who actually owned Tritons and had maybe done something about the problem.
I guess the most logical thing to do is to go and talk to some mechanics - see what they offer up as a solution. Just wanted to see what background info I could get so I am a bit more knowledgeable when discussing the problem
I guess the most logical thing to do is to go and talk to some mechanics - see what they offer up as a solution. Just wanted to see what background info I could get so I am a bit more knowledgeable when discussing the problem
2000 Triton GLX Dualcab, Bullbar, Hella Rallye 4000's, Flares, BFG AT's
www.4wdaus.com
------------------------------------------------------
www.4wdaus.com
------------------------------------------------------
After looking round the net for other posts regarding this problem, I have found the Mitsubishi L200 owners club in the UK, which is a 700 plus strong club/forum for owners of Mitsubishi L200 and similar (the UK version of the Triton). This is an excellent site and well worth a look for Triton owners.
http://www.l200.org.uk
Anyway, they had some extensive info on there re fixing Tritons turning circle, by adjusting the steering bump stops.
Armed with that info I adjusted my bump stops yesterday, and as a result have a much improved turning circle. I still have more adjustment possible before the tyres begin to rub on full lock, but will see how this first adjustment goes. So far so good.
Its a very simple adjustment. After putting steering onto full lock, look in front of the wheel thats sticking out, and you can see the steering arms. At the point where the steering arm would touch the chassis, is a bolt, with a locking nut, attached to the chassis. This what gets adjusted. Loosen the locking nut and hold it, then tighten the the bolt to the required height, and then re-tighten the lock nut. Do the same for the other side.
You must test your steering lock first with the vehicle stationery, to make sure you still have plenty of tolerance between the tyre and the chassis of the truck.
Don't forget to check on both left and right hand lock, the front and back of tyres for clearance to chassis
On the L200 site there were a few posts suggesting that you should check the steering fluid levels, and that this potentially may have caused some lockups on full lock acceleration. Have not had any such problems yet, and fluid levels remained same.
Its awesome having a reasonable turning circle. Now doing a U turn is only a 3 point turn, not 4 or 5
The pic below was taken after I made the adjustment. It is taken from the drivers side, looking in over the wheel. I had to clean off a fair bit of grease and crap before I recognised it.
Hope this helps any Triton driver that hasn't had the adjustment done. Its well worth it. And thanks to the guys on the UK L200 site. (a bit of stolen text along the way
)
Cheers
Steve K
http://www.l200.org.uk
Anyway, they had some extensive info on there re fixing Tritons turning circle, by adjusting the steering bump stops.
Armed with that info I adjusted my bump stops yesterday, and as a result have a much improved turning circle. I still have more adjustment possible before the tyres begin to rub on full lock, but will see how this first adjustment goes. So far so good.
Its a very simple adjustment. After putting steering onto full lock, look in front of the wheel thats sticking out, and you can see the steering arms. At the point where the steering arm would touch the chassis, is a bolt, with a locking nut, attached to the chassis. This what gets adjusted. Loosen the locking nut and hold it, then tighten the the bolt to the required height, and then re-tighten the lock nut. Do the same for the other side.
You must test your steering lock first with the vehicle stationery, to make sure you still have plenty of tolerance between the tyre and the chassis of the truck.
Don't forget to check on both left and right hand lock, the front and back of tyres for clearance to chassis
On the L200 site there were a few posts suggesting that you should check the steering fluid levels, and that this potentially may have caused some lockups on full lock acceleration. Have not had any such problems yet, and fluid levels remained same.
Its awesome having a reasonable turning circle. Now doing a U turn is only a 3 point turn, not 4 or 5
The pic below was taken after I made the adjustment. It is taken from the drivers side, looking in over the wheel. I had to clean off a fair bit of grease and crap before I recognised it.
Hope this helps any Triton driver that hasn't had the adjustment done. Its well worth it. And thanks to the guys on the UK L200 site. (a bit of stolen text along the way
)
Cheers
Steve K
You do not have the required permissions to view the files attached to this post.
2000 Triton GLX Dualcab, Bullbar, Hella Rallye 4000's, Flares, BFG AT's
www.4wdaus.com
------------------------------------------------------
www.4wdaus.com
------------------------------------------------------
:)
thought this was worth bumping. Its amazing what you find while trawling old posts.
Turning circle is one of the few things that I find annoying about my triton
Turning circle is one of the few things that I find annoying about my triton
MK (MY04) Triton GLS
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
i adjusted mine all the way in a while back. made a huge improvement
just put 31x1o.5 mtr's on (sunrasia rims with "navara offset") and still doesnt touch anywheres. only think im worried about is breaking a cv if when 4wding i give it to much at full lock.................. doubt it tho, not with only 31's atleast
just put 31x1o.5 mtr's on (sunrasia rims with "navara offset") and still doesnt touch anywheres. only think im worried about is breaking a cv if when 4wding i give it to much at full lock.................. doubt it tho, not with only 31's atleast
I have 265/75/16 BFG A/Ts on my '03 MK and the tyres touch the rubber sheet that stops the mud hosing into the engine bay 
. I dunno how much adjustment I'll be able to get out of it
Cheers
Blake
. I dunno how much adjustment I'll be able to get out of itCheers
Blake
MK (MY04) Triton GLS
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
31" BFG A/T
40mm torsion bar crank
[size=75]You should make a point of trying every experience once ... except incest and folk-dancing.[/size]
MK Triton Turning Circle
Yeah, I know this is ressurecting an old post but i didn't wan't to start a new post (keep all the info together....)
Anyway -
I often see people bagging the turning circle of the Dual Cab MK series Triton which is listed as 12.8m - so i though a bit of research was in order.
Al selection of dual cabs shows -
MK Triton 12.8m
D40 Navara 13.3m
D22 Navara 12.0m
Rodeo 12.6m
Hilux 12.6m
BT50 12.6m
Bravo 12.6m
ML Triton 11.8m
So there you go. The MK is large but not the largest.
The conclusion is that they are ALL huge (except maybe the new ML Triton) - especially the D40 Navara.
In regards to adjusting the bump stops, i think the GLX models with the thinner tyres will benefit from this. The GLS & GLX-R models have little adjustment due to the wider alloys and tyres fitted to these models.
DW
Anyway -
I often see people bagging the turning circle of the Dual Cab MK series Triton which is listed as 12.8m - so i though a bit of research was in order.
Al selection of dual cabs shows -
MK Triton 12.8m
D40 Navara 13.3m
D22 Navara 12.0m
Rodeo 12.6m
Hilux 12.6m
BT50 12.6m
Bravo 12.6m
ML Triton 11.8m
So there you go. The MK is large but not the largest.
The conclusion is that they are ALL huge (except maybe the new ML Triton) - especially the D40 Navara.
In regards to adjusting the bump stops, i think the GLX models with the thinner tyres will benefit from this. The GLS & GLX-R models have little adjustment due to the wider alloys and tyres fitted to these models.
DW
Who is online
Users browsing this forum: No registered users and 0 guests