Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Error codes 13 and 43 on a Holden VN motor

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 9
Joined: Thu Oct 07, 2004 12:39 pm

Error codes 13 and 43 on a Holden VN motor

Post by brett43au »

I have a VN motor in a Rodeo \ and am getting error code 13 Oxygen sensor error and 43 Knocking sensor error. I can find the Oxygen sensor but dont know were to look for the Knock sensor. The motor runs fine and has plenty of power dosent ping but the error codes always come back.
If any one knows were the Knocking sensor is that would be a help and if any one knows how to test these sensors it would be apreciated ( I have a good quality digital multimeter ) .
Thanks in advance
Brett
Top
Posts: 309
Joined: Tue Dec 03, 2002 11:43 am
Location: SOMEWHERE IN VICTORIA

Post by TUFF MAV »

The knock sensor should be on the side of the block. If it dosn't have a knock sensor just put the right size resistor in the wire for the knock sensor.

Kyle
BUGGERED IT'S A TOYOTA THING
Top
Posts: 194
Joined: Mon Mar 29, 2004 7:03 pm
Location: NOW IN TOWNSVILE

Post by skippy's GQ »

It's very common for the 3.8's to have 02 sensor codes, it just need to be replaced :)
88 GQ SWB 5''SUS LIFT 60MM BODY LIFT, FRONT LOKKA, NOW WITH 304, ...... :D

www.roverpark.com
Top
Posts: 349
Joined: Tue Nov 12, 2002 5:40 pm
Location: Central Coast NSW

Post by hophoar »

the knock sensor is located down by the oil filter, if your running a lumpy cam and roller rockers get it switched off in the program or you'll only be running in limp mode.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 3 guests