Hi guys,
Anyone here running the OME 2" Lift with 31's or bigger just wanted to know your opinions on the setup. Tossing up wether to go that way or the 3.5" system with 33's both from suburban 4x4. If you guys had any pics on a 2"lift with 31's please flick em over. Also is it possible to run 32's on the 2" OME lift?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Suspension Setup
Moderator: GUtripper
I used to own a TJ about 3 years ago.
I had 3 inch lift with 31's under it. Used OME Shocks and springs with a 1 inch spacer all round and poly airs in the rear. Fitted the poly air to carry 3 fuel cans on the customer rear bar for extended tours. I lowered the Transfer case for the lift and had 2 custom longer lower control arms made for the front. I also removed the Rear sway bar and had disconnects on the front.
About the only other thing to stop it scrubbing out was to add 2 washers to the Steering bump stop on both side. just saves the tires hitting on the lower control arms while in full lock.
It handled great.
The photo shows it down in the rear as I let the air out to climb out of the Creek up the cape and had 3 full Jerry can hangin off the rear. Pumped it up once again after climbing out.
I had 3 inch lift with 31's under it. Used OME Shocks and springs with a 1 inch spacer all round and poly airs in the rear. Fitted the poly air to carry 3 fuel cans on the customer rear bar for extended tours. I lowered the Transfer case for the lift and had 2 custom longer lower control arms made for the front. I also removed the Rear sway bar and had disconnects on the front.
About the only other thing to stop it scrubbing out was to add 2 washers to the Steering bump stop on both side. just saves the tires hitting on the lower control arms while in full lock.
It handled great.
The photo shows it down in the rear as I let the air out to climb out of the Creek up the cape and had 3 full Jerry can hangin off the rear. Pumped it up once again after climbing out.
You do not have the required permissions to view the files attached to this post.
Who is online
Users browsing this forum: No registered users and 6 guests