Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
So now we are to clean and strip the chassis, give it a lick of paint and at the same time looking at replacing the rear drum setup to disc brakes.
Am I right in saying the Bundera uses Hilux diffs/axles etc. So would it be possible the replace it with a Hilux rear disc ass?
The Bundy is very very very similar to a Hilux rear axle set up. I have done a few disc rear ends for Bundies a few years ago and the same conversion was used but from memory the wheel mounting flange is thinner on a Bundy compared to a Hilux so you need to space the wheel studs so the wheel nut dont run out of thread.
80UTE wrote:you need to space the wheel studs so the wheel nut dont run out of thread.
Aren't wheel spacers illegal?
I wrote "STUD" spacer's so you don't run out of thread when tightening the wheel nuts. The studspacers go between the head of the wheel stud and the axle wheel flange.
