Hi Guys
About half of the time I turn off engine it gives one rock and a slight shudder on stopping which goes through the vehicle. Engine mounts? GQ td42
Cheers Alex
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
engine rock
yeh if ur engine wobbles all over the shop when u rev it it'll be engine mounts ... but if its like running on then stop a few seconds after u turn the car off then its some thing else
H( * )( * )NZ loves B( * )( * )BIES
if a fat lady falls in the forest do the trees laugh?
[quote="RUFF"]although i didnt mean to, i squealed like a girl :armsup:[/quote]
if a fat lady falls in the forest do the trees laugh?
[quote="RUFF"]although i didnt mean to, i squealed like a girl :armsup:[/quote]
Thanks Hoonz
It don`t run on as in petrol pre -ignition. It just seens to stop with an instant shudder most of the time . Don`t know how much movement is permissable on revving the engine. Can you see if engine mounts are split by jacking up or something. No problems taking off or running etc.
Cheers Alex
It don`t run on as in petrol pre -ignition. It just seens to stop with an instant shudder most of the time . Don`t know how much movement is permissable on revving the engine. Can you see if engine mounts are split by jacking up or something. No problems taking off or running etc.
Cheers Alex
engine rock.
before you jack your engine up, get someone in the car and go 1st gear and let the clutch out to load the engine up, you then look at the engine mounts and see if they are tearing apart. try 1st gear and reverse. i just replaced an engine mount on my gq td42. cost from auto one was $85. easy to do but lining bolt holes up again is a real bugger. also when jacking up spread the weight as much as you can or long piece of timber on the side of the sump (where bolts are) and jack up. mate bent his sump and started car only to see bottom of conrod tear a hole in sump. nasty piece of work.
Who is online
Users browsing this forum: No registered users and 1 guest