Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Is there a DIY to change drivetrain fluids?
Is there a DIY to change drivetrain fluids?
I was wondering if there were a online DIY How-To manual to change the drivetrain fluids.
I am refering to the front and rear diffs, transfer case and gearbox fluids.
Im only used to doing these on a AWD car, where the gearbox and front diff both drain from the same sump and refilled via the dipstick.
The rear diff is also drained and refilled via the same sump bolt.
Now when I do some reading, all of the online stuff I have read basically refers to front diff, rear diff, gearbox and transfer case being totally different unit which sounds like they have their own sump bolts?
Exampe below:
Recommendation for: FORD Maverick (1988-1993)
Manual transmission MANUAL GEAR OIL 80
Manual capacity 3.9
Transfer case MANUAL GEAR OIL 80
Transfer capacity 2.2
Front differential HYPOID 80/90
Front diff capacity 5.4
Rear differential LIMSLIP 140
Rear diff capacity 2.1
Power steering ATF TOP UP FLUID
Im getting more and more confused the more information I read.
Having a look at this being done and posted online would be highly appreciative and extremely helpful.
PS: Ive only owned my truck for just under a month, first 4wd.
I am refering to the front and rear diffs, transfer case and gearbox fluids.
Im only used to doing these on a AWD car, where the gearbox and front diff both drain from the same sump and refilled via the dipstick.
The rear diff is also drained and refilled via the same sump bolt.
Now when I do some reading, all of the online stuff I have read basically refers to front diff, rear diff, gearbox and transfer case being totally different unit which sounds like they have their own sump bolts?
Exampe below:
Recommendation for: FORD Maverick (1988-1993)
Manual transmission MANUAL GEAR OIL 80
Manual capacity 3.9
Transfer case MANUAL GEAR OIL 80
Transfer capacity 2.2
Front differential HYPOID 80/90
Front diff capacity 5.4
Rear differential LIMSLIP 140
Rear diff capacity 2.1
Power steering ATF TOP UP FLUID
Im getting more and more confused the more information I read.
Having a look at this being done and posted online would be highly appreciative and extremely helpful.
PS: Ive only owned my truck for just under a month, first 4wd.
Re: Is there a DIY to change drivetrain fluids?
Now when I do some reading, all of the online stuff I have read basically refers to front diff, rear diff, gearbox and transfer case being totally different unit which sounds like they have their own sump bolts?
correct.
front and rear diffs undo the bolts underneath..
if you stand at the back of the car, you will see a 1/2inch (if I remember) square bolt thingy in the 'pumpkin'...
put the drain plug back in, then fill it there till it flows out of the filler hole., same on front.
correct.
front and rear diffs undo the bolts underneath..
if you stand at the back of the car, you will see a 1/2inch (if I remember) square bolt thingy in the 'pumpkin'...
put the drain plug back in, then fill it there till it flows out of the filler hole., same on front.
Al is simple if you take a good look at it.
Diffs - drain at bottom and fill thru the filler plug.
G/Box - same deal exit plug at side of the box and filler same side halfway up
Transfer - same - drain bottom - filler plug opposite side half up
In all cases fill until the oil come out the filler hole (on level ground) using an oil suction pump is a big plus and less messy.
Dont over tighten plugs and use some plumbers tape on the threads to seal. Don`t use silicon as it is a pourous seal.
Diffs - drain at bottom and fill thru the filler plug.
G/Box - same deal exit plug at side of the box and filler same side halfway up
Transfer - same - drain bottom - filler plug opposite side half up
In all cases fill until the oil come out the filler hole (on level ground) using an oil suction pump is a big plus and less messy.
Dont over tighten plugs and use some plumbers tape on the threads to seal. Don`t use silicon as it is a pourous seal.
Growing old is mandatory
Growing up is optional
Growing up is optional
Buy the service manual.toy77 wrote:hi guys i am in a similar position to this.
new truck (89 gq patrol). i have no dramas taking the oils out or refilling, but i am after recomoendation on which oils to use?
the 4x4 is not used for serious offroad, just sand and towing etc, as well as daily driving.
Cheers
Stew
That, or the little book that lives in the glovebox also has oil type information.
Or the GQ bible will most likely have it.
Re: Is there a DIY to change drivetrain fluids?
Square bolt thingy in the 'pumpkin'bogged wrote:Now when I do some reading, all of the online stuff I have read basically refers to front diff, rear diff, gearbox and transfer case being totally different unit which sounds like they have their own sump bolts?
correct.
front and rear diffs undo the bolts underneath..
if you stand at the back of the car, you will see a 1/2inch (if I remember) square bolt thingy in the 'pumpkin'...
put the drain plug back in, then fill it there till it flows out of the filler hole., same on front.
Love this discription
i use penrite oil on my 92 SWB mav, there was a little while ago a similar question asked about oils and most said penrite, have a search for the link.toy77 wrote:hi guys i am in a similar position to this.
new truck (89 gq patrol). i have no dramas taking the oils out or refilling, but i am after recomoendation on which oils to use?
the 4x4 is not used for serious offroad, just sand and towing etc, as well as daily driving.
Cheers
Stew
mine is on straight gas and running twin ARB lockers and used for hard offroading.
i use:
HPRGAS for engine
80W/90 Hypoid gear oil for g/box and transfer
85W140 Limslip diff oil for diffs.
Gq ute new built
Who is online
Users browsing this forum: No registered users and 99 guests