Attn: Moose

[Ferwoaza]

Heya mate, got a question about your rear lights. Where did you pick up the lights to put them on the verticle rather than the normal horizontal in the rear section...u know what I mean 8)

I've been thinking about doing the same thing for a while, should help departure angle...what truck did you get them off?

Thanks matey

Murray

[moose]

the truck is a 93 model , but i think the lights came from a 89/90 model !! will verify 2moro & let you know !!!{possibly even earlier model}

[*BESTY*]

The lights came from a Diahatsu import - I believe it was a narrow track, but they all fit.
ADR's don't really allow the lights up there as they are blocked out by the spare on the rear door.
I've had to move my spare carrier over - strengthened it as well to seat the 35" Centipede.

Andrew

[Ferwoaza]

Stupid ADRs...hmm...might go the other way then...bit of C channel steel (or checkerplate if I can find it) cut out a few holes, whack in the lights...but make it about 1/3rd the width of the existing ones

Thanks for the info mate. I've tracked down a lot of info about the body lift too, even got the required bolt size...so this is on track to happen mid November.