Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
fuel tank level sender
Road Ranger
fuel tank level sender
it stoped working yesterday, got in some deep water, flooded inside and was up over 2" above the bonnet on the GQ, i noticed it wasn't working when I hit the tarmac again on the way home. would it be the sender f****ed, wire shorted or something else?
If the above post did not offend you in any way please PM me so I can try harder!!
Just a thought, check the wiring to the sender, if you have got any cracks or penetrations in the wiring, the water has possibly either blown the wiring or the resistor on the sender. It might be worth taking a day to drop the tank out and visually check the sender.
Duct tape is like the force it has a Dark side a Light side and holds everything together
Just a thought, check the wiring to the sender, if you have got any cracks or penetrations in the wiring, the water has possibly either blown the wiring or the resistor on the sender. It might be worth taking a day to drop the tank out and visually check the sender.
Duct tape is like the force it has a Dark side a Light side and holds everything together
Yeah, pull it out via inspection plate (a feature that would be *very* handy on the MQ!), trace the wires back, and then stick an ohmmeter across the wires. Move the sender back and forth and see if you get a resistance change. If not, move your measurement point closer to the sender (just cut the insulation off and tape it back up well later) until you find the fault. If you get all the way to the sender, you know where the problem is 
Can also do the opposite - alternatively short and open the wire from the gauge and look for needle movement.

Can also do the opposite - alternatively short and open the wire from the gauge and look for needle movement.
* Nothing is foolproof to a sufficiently talented fool *
Who is online
Users browsing this forum: No registered users and 2 guests