Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

60 series Cold Start problems

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

60 series Cold Start problems

Post by joel HJ60 »

Don't know what to make of this. When I start my car, after its been sitting outside all night, it really struggles at idle , really struggles. My manual says it should idle at 650rpm, which it does once it's at op. temp. But when it's cold it's below the 500 mark, sometimes hunting for the desired 650rpm. Anyone had the same problems and/or know what to do.
Should I put up with it, or is there a way to fix it?

For what its worth I use Castrol RX Super 15W 40 oil.

Thanks Joel
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 97
Joined: Tue Sep 23, 2003 6:58 pm
Location: canberra

Post by tukadafoonday »

i recond you should just use your choke like most of us old car users do :idea: :finger:
Fj40 '84, 2F. PWS, 2" extended shackles, detroit rear, soon lockrite front. huge 31" tires :( one day some big mothers!
Posts: 1031
Joined: Sun May 01, 2005 10:22 pm
Location: Newcastle 2300

Post by joel HJ60 »

Theres no choke on mine, I usually pull the hand throttle out a bit.
[b]1985 HJ60[/b]

[url]http://forum.ih8mud.com/60-series-wagons[/url]
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

shouldnt do that at all

could be low compression in one or more pistons, get a compression test?

could be your pre(and post) heating system (glow plugs) not working, check to see if there is voltage supplied to glow plugs before and after start. Check all your glow plugs. the glow system should continue heating until engine is up to a reasonable temp.

could be loose fuel lines. Had this with my 2H. it would miss and run really bad at low revs, but at 1500+ it was fine. Took it to diesel place and he tightened the fuel lines and it fixed it straight away. (mine did it when warm aswell though)
Posts: 285
Joined: Sun Aug 15, 2004 9:31 am
Location: Sydney

Post by dibbz »

Mine used to be a smooth idle from cold start(s) until I changed mechanic recently, now its a bit rougher and seems it miss a couple of beats for the first say 7 seconds perhaps, not very long anyway.

But it also runs a bit sprightlier now, a little bit more pert than it was.

Maybe be a little more conservative on its tuning?

Also when I park in my driveway which is angled higher at the front I always need to start it a second time as the oil pressure takes a bit longer to get up.

If i'm lucky and it is screwed I only have another 150,000k/s left in my 2H before I can blow some cash o a 12H-T :) hehe..
Posts: 541
Joined: Sun Sep 28, 2003 5:04 pm
Location: in the shower..

Post by carts »

Don't worry, i have the same issue on my 2h. Just pull the hand throttle out a little at idle when it is cold. This will bring the engine rpm up to normal. When it warms up, push the throttle back in.

When the motor is cold, this is fairly normal, as long as it isn't missing.

Your system will still be glowing correctly if the car starts on all cylinders with no smoke, just idling a little lower. As far as i am aware, this just means that the motor isn't up to its most efficient running temperature.
If you want a spare 60 for bits-
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
Posts: 561
Joined: Sun Aug 01, 2004 5:34 pm
Location: Bundy...

Post by toyotroop »

I have this as well, i changed the alt/reg, and replaced all the glow plugs and was surprised to find that it still ran rough on cold starts.... but i will say, you would know if one of your glow plugs was dead cos it would shake like hell. :lol:

jeff
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

toyotroop wrote:I have this as well, i changed the alt/reg, and replaced all the glow plugs and was surprised to find that it still ran rough on cold starts.... but i will say, you would know if one of your glow plugs was dead cos it would shake like hell. :lol:

jeff
yep and pump a shitload of white smoke generally.

i guess being in queensland i dont experience the problems you guys do, since its not as cold when i "cold start"
Posts: 417
Joined: Wed Jul 13, 2005 8:30 pm
Location: NSW

Post by Modified Toy »

Had the same problem with a 60 series runs very rough when cold ok when you bring the revs up.
The fitting that srews into the pump was loose not the pipe pulled the pipes off tightened all the fittings slightly in the pump and now it runs like a dream.
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

Modified Toy wrote:Had the same problem with a 60 series runs very rough when cold ok when you bring the revs up.
The fitting that srews into the pump was loose not the pipe pulled the pipes off tightened all the fittings slightly in the pump and now it runs like a dream.
sorry thats what i meant
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest