Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

What Gearbox and Transfer Case Oil to use in the Luxie???

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 1326
Joined: Thu Mar 13, 2003 2:26 pm
Location: North Sydney, Australia

What Gearbox and Transfer Case Oil to use in the Luxie???

Post by Toyo Truck »

Hi Guys,

Want to do a bit of maintenance to the old luxie before Saturday nights
trip up the coast.
I have replaced most stuff, air-filter, oil-filter, engine oil, etc,
but I wanna swap my gearbox and transfer-case oils.

I used Castrol GTX MAGNATEC for the old 22R engine
LSX-90 LSD fluid for F&R air-lockers
BUT
What oil do I use for the gearbox and transfer case??
What brand, and what viscosity are we talking here? I'll go and
buy it tonight from supercheap, so any answers you guys can come
up with would be sweet.

Thanks,
Bart
The Lux is back. New and Improved v2.0!
Posts: 6021
Joined: Sat Feb 15, 2003 11:01 pm
Location: Shed.

Post by dumbdunce »

any GL4 or 5 anywhere from 75-80(w) - 90-140 will do. you could try Dexron ATF in the transfer to squeeze a tad more efficiency out of it.


why are you going to dumb stockton instead of willowglen??
Free air locker to the first 20 callers!
Posts: 75
Joined: Fri Dec 03, 2004 1:31 am
Location: Seymour, Vic

Post by GoPies »

Just did the Transfer case in the 80 and the workshop book says GL5,SAE 75w-90 so should be the same.
96 Landcruiser

"It's all good fun until someone loses an eye"
Posts: 1326
Joined: Thu Mar 13, 2003 2:26 pm
Location: North Sydney, Australia

Post by Toyo Truck »

DD,
Going to dumb stockton cause all the boys made a last minute
random decision and stocktons was the winner?
I don't actually know why, but it sounds like fun so we are going up there.
My mate may be bringing his dune buggy along!!
And I think Ryan is going to race it wit the 5.0L!!

Whats the difference between
75w - 80?
75w - 90?
75w - 120?
Which is best for the luxie 5-speed gearbox though?
And this dexron ATF you speak of, what viscosity is it?
Where can I get it from and what is it usually used for?
And if I can't get the dexron ATF, which of the above
mentioned gear oils should I use?

Go Pies,
How long ago did you do the change? Does it work better now?
Are you happy with the 75w-90?

Cheers,
Bart
The Lux is back. New and Improved v2.0!
Posts: 75
Joined: Fri Dec 03, 2004 1:31 am
Location: Seymour, Vic

Post by GoPies »

I did it on Sunday and haven't really noticed much difference, maybe a little less clunky i suppose. I don't think it had the right oil in there before hand, it was really thin and this is the first oil change since I've had it.
96 Landcruiser

"It's all good fun until someone loses an eye"
Posts: 1326
Joined: Thu Mar 13, 2003 2:26 pm
Location: North Sydney, Australia

Post by Toyo Truck »

Hey Guys,

I've been swapping between Dexron ATF and the normal 75W-90 oil
in the transfer case and I can't really tell the difference.
Both seem to work well enough.

Which one will provide more protection from wear in the long term?
The 75W-90 or the Dexron Auto Trans Fluid??
Not so worried about a smooth change from 4H to 4L, but more
concerned with big loads on the transfer from twin lockers.

I was thinking also, what about that Lucas oil stabilizer stuff??
can I put a bit of this into the transfer? Or is this stuff overated??

Cheers,
Bart
The Lux is back. New and Improved v2.0!
Posts: 6021
Joined: Sat Feb 15, 2003 11:01 pm
Location: Shed.

Post by dumbdunce »

Toyo Truck wrote:Hey Guys,

I've been swapping between Dexron ATF and the normal 75W-90 oil
in the transfer case and I can't really tell the difference.
Both seem to work well enough.

Which one will provide more protection from wear in the long term?
The 75W-90 or the Dexron Auto Trans Fluid??
Not so worried about a smooth change from 4H to 4L, but more
concerned with big loads on the transfer from twin lockers.

I was thinking also, what about that Lucas oil stabilizer stuff??
can I put a bit of this into the transfer? Or is this stuff overated??

Cheers,
Bart
better extreme pressure performance from the hypoid gear oil (the 75/90 stuff) but better fuel economy and slightly cooler operation from the dexron. Probably better to stay away from the Lucas Stabiliser - very thick oil can gererate a lot of heat uner highway conditions, and you can get film shearing which ends up with metal to metal contact between gears. maybe a small mount could help a wearing gearbox but gearboxes are designed for a specific oil thickness.
Free air locker to the first 20 callers!
Posts: 1326
Joined: Thu Mar 13, 2003 2:26 pm
Location: North Sydney, Australia

Post by Toyo Truck »

Thanks DD,

Once again you have come through with the goods.
I will stick with the Hypoid Gear Oil then (75w90)
in both the transmission and the transfer case.
I can also buy in bulk and save $$

Oh and before I change the oil,
The front and rear seals on the transfer case seem to be leaking
slightly (only a little bit wet) is there anything I can do to help
prolong the life of these seals? I was speaking to carts the other
night and he said its a pretty easy job to change the seals, but I
am hesitant to try :?

Cheers,
Bart
The Lux is back. New and Improved v2.0!
Posts: 57
Joined: Sun Nov 02, 2003 3:04 pm
Location: bind.tk

Post by Jonathan Ferguson »

Toyo Truck wrote:Thanks DD,

Once again you have come through with the goods.
I will stick with the Hypoid Gear Oil then (75w90)
in both the transmission and the transfer case.
I can also buy in bulk and save $$

Oh and before I change the oil,
The front and rear seals on the transfer case seem to be leaking
slightly (only a little bit wet) is there anything I can do to help
prolong the life of these seals? I was speaking to carts the other
night and he said its a pretty easy job to change the seals, but I
am hesitant to try :?

Cheers,
Bart
Yes, it is easy. http://forum.ih8mud.com/showthread.php?t=70017
[b][i][u][color=Orange]LIFE AIN'T WORTH LIVING WHEN YOU DIE BEFORE YOU'RE MEANT TO![/color][/u][/i][/b]
Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests