Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Slowzuki
Slowzuki
My truck has a hot 1.3. weber 32/32, Camtech stage 1 cam, Genie headers, stainless 2" exhaust, 2" body lift,buggyleaf rear, Climax front, Kings long travel springs, Toughdog rears, Rancho 9000x fronts, 32' Mongrels on F100 8" rims, Warn 8000lb. lowmount, 2x 170 lightforce, 2x Night stalker,2x 55w. peripheral spotties, 2x 50w. rocklights,Craig davies thermofan with incab isolator, snorkel,internal winch controls,Shrockworks type sliders,Snake Racing shockhoops,108amp EL Falcon alternator ,Lockrights front and back, Calmini 5.14s, 3.90 centres.
You do not have the required permissions to view the files attached to this post.
Happiness is life in low range!
ofr57,
I wouldn't leave the climax shackles unpinned on the road, but they work good off-road. I haven't felt the truck doing anything wierd offroad. Except going further than it used to without them!! Obviously your pinion angle is increased, but that occurs even with longer shackles, so you just bear that in mind always when lifting front ends.
I wouldn't leave the climax shackles unpinned on the road, but they work good off-road. I haven't felt the truck doing anything wierd offroad. Except going further than it used to without them!! Obviously your pinion angle is increased, but that occurs even with longer shackles, so you just bear that in mind always when lifting front ends.
Happiness is life in low range!
alternator
Yes, it was the best I could find.108 amps, electronic internal regulator, easy fit to the Zuki, typically 95-100 bucks and only needed to change the drive pulley from a multigroove to a v-belt configuration and a switch from a 25amp fusible link to a 50 ampere unit. Runs 600 watts of light O.K. and a Warn 8000 winch.
Happiness is life in low range!
Who is online
Users browsing this forum: No registered users and 0 guests