Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
My MQ Wobbles!!
My MQ Wobbles!!
Howdy all,
I don't know if this is a common problem or not but at the 75-80km/h mark, i get a violent wobble in the front end. It sounds like the steering damper is taking a good hammering.
The only way I've found to fix this, while driving, is to either floor it and get above 80km/h (which isn't compatable with my current license points situation in some areas) or slow to about 60-65km/h.
I thought I'd fixed the problem when I replaced the front wheel bearings and saw the state of the old ones (that almost literally fell apart in my hands, no grease!) but unfortunatlty it didn't work.
It only used to do it every now and then and when it's in that speed range, it seems to be started by a bump in the road. But nowadays it's almost a sure thing.
Could the damper be the issue? If so how can I check it. Or is it a balance thing or steering thing??
Any help or suggestions would be greatly appreciated as I now have to change the seat covers coz the missus took it for a drive!
Cheers,
Lewie
FYI it has 164K kms, OME suspension and 31in tyres in good nick.
I don't know if this is a common problem or not but at the 75-80km/h mark, i get a violent wobble in the front end. It sounds like the steering damper is taking a good hammering.
The only way I've found to fix this, while driving, is to either floor it and get above 80km/h (which isn't compatable with my current license points situation in some areas) or slow to about 60-65km/h.
I thought I'd fixed the problem when I replaced the front wheel bearings and saw the state of the old ones (that almost literally fell apart in my hands, no grease!) but unfortunatlty it didn't work.
It only used to do it every now and then and when it's in that speed range, it seems to be started by a bump in the road. But nowadays it's almost a sure thing.
Could the damper be the issue? If so how can I check it. Or is it a balance thing or steering thing??
Any help or suggestions would be greatly appreciated as I now have to change the seat covers coz the missus took it for a drive!
Cheers,
Lewie
FYI it has 164K kms, OME suspension and 31in tyres in good nick.
Yeah..... Nuthin!
84' SWB MQ Nissan Patrol
84' SWB MQ Nissan Patrol
the bushes in the front sheckles where they attach to chassis common problem but easy fix
if you can't do it yourself i recommend a pedders store as they have all the parts
if you can't do it yourself i recommend a pedders store as they have all the parts
Style Side Maverick Ute
4.2 Turbo Diesel
35" Simex
4" Procomp suspension
2" Bodylift
Fibreglass Stuff....
Now highmount & Plasma :d
4.2 Turbo Diesel
35" Simex
4" Procomp suspension
2" Bodylift
Fibreglass Stuff....
Now highmount & Plasma :d
ONE OF 3 THINGS TO TRY.
1. check to make sure your U bolts are tight both front and rear. if not tighten them
2. There is a steering stabalizer bolted to your front chassis crossmember, all the relay rods run into this on your steering and then over to the tie rod.
There is a grease nipple on this. GREASE THIS
3. check how worn your bushes are on your front spring hangers and replace if needed, or just grease up depending on how bad they are, also check for chassis cracks on those front spring hangers.
check all these things, buy a tube of grease and go over the whole car and you will find more than likely your problem will be solved.
IF the problem still persists, your tie rod ends or steering bal joints are shagged, so may be tought to replace, but only after trying all else.
Screwy
1. check to make sure your U bolts are tight both front and rear. if not tighten them
2. There is a steering stabalizer bolted to your front chassis crossmember, all the relay rods run into this on your steering and then over to the tie rod.
There is a grease nipple on this. GREASE THIS
3. check how worn your bushes are on your front spring hangers and replace if needed, or just grease up depending on how bad they are, also check for chassis cracks on those front spring hangers.
check all these things, buy a tube of grease and go over the whole car and you will find more than likely your problem will be solved.
IF the problem still persists, your tie rod ends or steering bal joints are shagged, so may be tought to replace, but only after trying all else.
Screwy
TUFF TRUCK TEAM OPPOSITE LOCK Proudly Sponsored By:
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
mq
Two more things
1. swivell hub bearings for tightness and
2. wheel ballance
1. swivell hub bearings for tightness and
2. wheel ballance
Remember some days your the pigeon and other days your the statue
God of Magnificant Ideas!
Grease is a waste of time if its worn....Screwy_ScrewBall wrote: 2. There is a steering stabalizer bolted to your front chassis crossmember, all the relay rods run into this on your steering and then over to the tie rod.
There is a grease nipple on this. GREASE THIS
better off fitting new bushes ( $16.80 last set I fitted )
USE THE NEOPRANE UNITS ........ NOT THE RUBBER ONES
to check......
Get someone to move the steering wheel in a similar manor to the "shimmy" you are describing, while you look for movement in the front end steering joints.
Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Thanks to all those who replied to my deliema.
I tried everything (by that, I mean the ones that cost me no $$) that the kind people who replied suggested but in the end I removed 1 of the adjustment shims from the top and bottom bearings in the steering knuckle flange.
The bearings still looked like they were in good nick and it sorted out the problem so I think I'll leave it at that. Unless I've done something really bad! Gurus?.............
Cheers
Lewie
I tried everything (by that, I mean the ones that cost me no $$) that the kind people who replied suggested but in the end I removed 1 of the adjustment shims from the top and bottom bearings in the steering knuckle flange.
The bearings still looked like they were in good nick and it sorted out the problem so I think I'll leave it at that. Unless I've done something really bad! Gurus?.............
Cheers
Lewie
Yeah..... Nuthin!
84' SWB MQ Nissan Patrol
84' SWB MQ Nissan Patrol
Who is online
Users browsing this forum: No registered users and 38 guests