Had a bit of a search and couldnt find too much on the weights of the rover drive tran. I found the 3.5 weighs aboyut 144kg, but im also after the 3.9 (is there any differance), the ZF Auto and the transfer case.
Adam
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Engine/Gearbox/Trans Weights
Moderator: Micka
Engine/Gearbox/Trans Weights
----HillBilly Engineering----
for sum unknown reason i have the figure of approx 380 kgs for 3.9V8-ZFAuto-LT230.... and i tried searching for it cause i beleive it was in a thread on ol (might not have been) about putting them into the buggys???
difference between 3.5 and 3.9 is very minimal.... my brains not workin properly today
ill keep searching and put up anything i find
difference between 3.5 and 3.9 is very minimal.... my brains not workin properly today
ill keep searching and put up anything i find
Who is online
Users browsing this forum: No registered users and 0 guests