Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

60 series king pin cap measurements.

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

60 series king pin cap measurements.

Post by pongo »

I am after the measurements of the bolt holes of the top cap. Wendle suggested that maybe the high steer arms off a 60 might fit a mq/k patrol as the bearings are the same. If it does or is close we are in business. Probly wont but we might be able to make it work.


Thanks and here is hopeing
Top
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

Pleaze guys, Only take 2 mins to check. I drive a toyota as well so its not all that bad.
Top
Posts: 568
Joined: Fri Jan 10, 2003 6:38 pm
Location: Darwin

Post by Sixty »

Length centre to centre 55mm
Width centre to centre 31mm
Hole diameter 13mm
Luv the sound of a diesel,
especially a Chev 6.2!
Its GONE.........Replaced by a qik HDJ105.

The bigger the boy, the bigger the TOY!!
Top
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

The patrol is 50mm x 50mm centre to centre and 11mm holes

SO no good to me i think :roll:


Thanks for the help
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 1 guest